How many biological indicators must a Canadian clinic run per sterilizer per week?

Six CliniEco 24-hour biological indicator vials with red caps and 24 h readout labels, steam

How many biological indicators must a Canadian clinic run per sterilizer per week?

A clinic with two sterilizers and a five-day week does not need two indicators a week. It needs ten. The single weekly test quoted in many policy documents is the American baseline, and it is the wrong number for an Ontario office running its sterilizers every clinical day.

The arithmetic is short: one indicator per sterilizer for each day that sterilizer is used. Everything else follows from that sentence, including the pack size the clinic should be ordering. A 25-pack of 24-hour self-contained indicators covers a single-sterilizer clinic for five weeks, and the same pack covers a two-sterilizer clinic for two and a half.

How many biological indicators does one sterilizer need in a week?

Multiply the number of sterilizers by the number of days each one is used, then read the row. This is the number an inspector checks against the log, and it is the number a purchasing decision should be built on.

Sterilizers in service 3 clinical days 5 clinical days 6 clinical days
One 3 per week 5 per week 6 per week
Two 6 per week 10 per week 12 per week
Three 9 per week 15 per week 18 per week

A five-day, two-sterilizer office therefore runs about 43 indicators a month and 520 a year. That is the figure to hold against the annual spend, and it is the figure most often understated by clinics that plan on a weekly test.

CliniEco 24-hour biological indicators, 25 sterile indicators per pack, Bacillus stearothermophilus ATCC 7953

Are biological indicators daily or weekly in Canada?

Ontario offices test each sterilizer on each day it is used, which is the daily reading of the requirement. The weekly figure comes from the American minimum published in AAMI ST79 and echoed by the CDC, and it is a minimum rather than a target: a sterilizer monitored once a week has six days of unverified loads behind it.

Where a provincial college has published no frequency, CSA Z314 and the manufacturer's instructions are what an inspection falls back on, and neither promises weekly is enough. Cite the document actually followed, by name and date.

Which pack size should a clinic order?

Pack size is a consequence of the weekly figure, not a preference. Match the pack to the monthly count and let the ordering cycle absorb the remainder.

Six CliniEco 24-hour biological indicator vials with red caps and 24 h readout labels, steam

Weekly indicators Monthly Pack that fits Why
3 to 5 13 to 22 25-pack one pack per month, no overstock
6 to 10 26 to 43 25-pack, two at a time keeps one sealed pack in reserve
12 to 15 52 to 65 50-pack one pack per month with a small margin
18 and above 78 and above Two 50-packs matches a multi-site or a six-day week

Readout time is a separate choice and does not change the count. The one-hour fluorescence indicators answer faster when a load is waiting for release; the three-hour fluorescence indicators sit between the two.

What do you record when the indicator is read?

Six fields, every time: date, sterilizer identifier, indicator lot, incubator temperature, readout time, and pass or fail with initials. A result without the lot number cannot be traced if a batch of indicators later fails its own positive control. The 24-well dry-block incubator holds a week of a two-sterilizer clinic in one run at one set temperature.

Not sure how this applies to your own setup? Ask a sterilization compliance specialist and you will get a written answer specific to your equipment and province, with the regulation or standard cited.

Ordering for a multi-site group? Wholesale and multi-site ordering covers case pricing and account setup, and the B2B wholesale collection lists the lines stocked for institutional buyers. Reselling? become a distributor.

Running a dental practice? The dental practice supply page groups the indicators, pouches and log sheets a clinic reorders together.

References

  1. CSA Z314:23, Canadian medical device reprocessing in all health care settings — standard record (checked 12 November 2026)
  2. IPAC checklist for dental practice, core elements — Public Health Ontario (checked 12 November 2026)

Printable companion: the free sterilization log set carries the load record and the indicator result on one sheet.

Want the weekly figure worked out from your own cycle count? The sterilization monitoring usage calculator turns sterilizers and operating days into an annual indicator count.

Related Reading

Frequently Asked Questions

Do I need a biological indicator for every load?

No. The unit of testing is the sterilizer and the day it is used, so several loads on one day share one indicator.

Is weekly testing enough in Canada?

Weekly is the American baseline, set as a minimum. A Canadian office that writes weekly into its policy without checking its own provincial college is quoting another jurisdiction.

Which readout time should a clinic buy?

Twenty-four hour indicators are the working standard. One-hour and three-hour fluorescence readouts shorten the wait when a load has to be released quickly.

What has to be written down with the result?

Date, sterilizer identifier, indicator lot, incubator temperature, readout time, pass or fail, and the initials of whoever read it.

Last updated: November 2026. CliniEco Medical is a licensed medical device establishment (MDEL #35334).

Already working with clinics? Become a regional representative.