How Many Aesthetic Procedure Kit Does a Med Spa Use Per Month in Canada?

The printed face of a self-sealing sterilization pouch showing bilingual handling text, the size 2.5 x 4 inch and 6 x 10 cm, internal and external indicators and a Class 4 marking

The number a med spa needs is not a target, it is a count of openings. A kit is consumed when the seal is broken, not when the procedure succeeds, so the monthly figure is the number of procedures booked for that room plus the kits that get opened and not used. Once that figure exists, the reorder point, the storage shelf and the case quantity all follow from it, and the argument about whether to hold one case or three stops being an argument.

The component lines in the current listing are a sterile blunt fill cannula in selected gauges and a low dead space luer-lock syringe with needle, with the post-procedure repair mask trial pack as the consumable that tends to signal the month's volume before the kit count does.

Quick facts

  • A Canadian med spa's kit count is a device group count: the Medical Devices Regulations define a group as "a collection of medical devices, such as a procedure pack or tray, that is sold under a single name" (SOR/98-282, s. 1, read 12 November 2026).
  • One procedure consumes one kit in a room that opens per patient, because the sterile barrier is a single-use barrier and cannot be re-formed by closing the pouch.
  • The monthly multiplier is 4.33 weeks, not 4: 52 weeks divided by 12 months.
  • A booking count misses four sources of consumption: opened-and-unused trays, trial or training sessions, samples given to a referring clinician, and expired stock.
  • A "case" is not defined in Canadian or American device law, so a monthly figure is only actionable when the pack and case configuration is written beside it.

How do you calculate kits per month from bookings?

Three numbers, multiplied, then a margin added.

Monthly kits = procedures per week × 4.33 × kits per procedure, plus a wastage margin expressed as a percentage of that product. For a room that opens one kit per patient, the middle factor is 1. Rooms that lay out a backup tray for a bilateral or a revision procedure use a factor above 1, and a room that pre-opens trays before the patient arrives uses a factor closer to 1.15 without being able to say why.

Procedures per week Kits at one per procedure Monthly (× 4.33) With a 5% opening margin
10 10 44 46
20 20 87 91
30 30 130 137
40 40 174 182
60 60 260 273

The 5% column is where rooms under-order, and it is also where the provincial picture enters: a room covered by O. Reg. 136/18 in Ontario has to record its disinfectant concentration and discard date, while a room in Quebec answers to the biomedical waste regulation instead. The count itself is federal; the paperwork around it is not. A kit opened for a patient who then leaves without treatment, a kit opened to show a colleague the contents, a kit opened because the tray on the trolley had been there since morning — those are all consumption and none of them appears in the booking system.

What does a booking count miss?

Four things, and only one of them is visible on a stock report.

Source of consumption Typical size How to count it
Opened and not used 2 to 5 per cent of openings in a busy room Reason code on the daily sheet
Trial or training sessions Clustered, often several in one week Separate line, not averaged into the month
Samples to referring clinicians Seasonal, tied to marketing Issued against a name, not a shelf
Expired or damaged stock Small per month, expensive when found in an audit Date check at receiving, not at opening

The second row is the one that distorts a forecast. A room that trains two new practitioners in the same month can double its openings for a fortnight and then return to its baseline, which is why a month with training should be recorded as a month with training rather than used as the new average.

Why is a kit counted per procedure rather than per component?

Because the components are not consumed at the same rate, and the kit is the only unit that bundles them.

The sharps container behind the count is specified the same way, against the CSA Z316.6 series. A kit contains a drape, a syringe, a cannula, swabs and gloves, and each of those has its own consumption rate if bought separately: gloves go by the pair per contact, swabs by the pack, cannulas by the gauge that the day's cases happen to need. Buying them separately means five reorder points and five chances of being short. Buying them as a group means one count. The federal definition is the reason the group can be sold and counted as one thing, and it is also the reason the group has to be specified as one thing.

The syringe inside is the component with the sharpest specification boundary. ISO 7886-1:2017 covers empty sterile single-use hypodermic syringes, states that it does not provide requirements for lot release, and limits its scope to syringes intended for use immediately after filling. The packaging around it follows ISO 11607-1, which is the standard that makes the pouch a sterile barrier system rather than a bag.

The printed face of a self-sealing sterilization pouch showing bilingual handling text, the size 2.5 x 4 inch and 6 x 10 cm, internal and external indicators and a Class 4 marking
The seal is the unit of consumption. A pouch that has been opened and closed again has lost its sterile barrier, so the count is openings, not uses.

How does the monthly kit count differ between Canada and the United States?

The arithmetic is the same; the assumptions behind it are not.

Item Canada United States
What the kit is, legally A medical device group under SOR/98-282 A convenience kit or a device, assembled by a registered establishment
Who answers for the assembled kit The manufacturer named on the label, with the distributor holding an establishment licence (s. 44) The kit assembler, through registration and listing
Gloves in the kit Class II, licensed Class I, exempt under 21 CFR 880.6250
Disposal rule that shapes the count Provincial waste rules and provincial occupational rules Federal occupational rule, 29 CFR 1910.1030
Label language English or French minimum, both for public sale (s. 23) English, plus state requirements

Clinical guidance for the room itself is provincial or national rather than federal: Public Health Ontario's clinical office practice material on one side of the border and the CDC's disinfection and sterilization guidance on the other are both built around the same routine-practices core. The second row is the practical one. In Canada, a med spa buying for its own use is not the licence holder and does not need an establishment licence; the distributor it buys from does, and section 44(3) puts the check on the importer. That means the monthly count can be built around a single supplier without the room holding any regulatory status of its own — but it also means a supplier change is a compliance event, not just a price event.

The FDA device programme, the CDC's disinfection and sterilization guidance and Health Canada's medical devices portal are the three reference points most rooms end up comparing when a group practice operates on both sides of the border.

How does the case-unit conversion differ between Canada and the United States?

It changes the order, and the order is what the month actually runs on.

Neither country defines "case," so the conversion from kits to cases is a packing convention. If a case holds ten inner boxes of five kits, the case is fifty kits, and a room opening 91 kits a month needs two cases with nine kits carried over — a figure that is only visible when the inner configuration is written down. The classification part for devices under 21 CFR Part 880 does not address shipping units, and the Canadian regulation defines the group but not the case.

Monthly kits Case of 20 Case of 50 Case of 100
46 3 cases (14 spare) 1 case (4 spare) 1 case (54 spare)
91 5 cases (9 spare) 2 cases (9 spare) 1 case (9 spare)
182 10 cases (18 spare) 4 cases (18 spare) 2 cases (18 spare)

Glove and drape performance inside that case is graded by the ANSI/AAMI PB70 classification, which is why the specification sheet and the case sheet are two documents rather than one. The pattern in that table is the reason a small room should not buy the large case even at a better unit price: the spare becomes shelf life, and shelf life becomes expiry.

What should be recorded every month?

Three lines, and the third is what makes next month's order right.

Record What it holds Who signs it
Procedures performed, by practitioner The denominator for the kit count Room lead
Kits opened, including unused ones The numerator, with reason codes Whoever opens the kit
Stock on hand at month end, by component What the next order has to bring back to par Receiving clerk

The third line is the one that catches the drift. A room that orders on the same quantity every month regardless of the first two lines is not managing stock, it is repeating an order, and the month it runs short will be the month it also discovers it has three expired cases at the back of the shelf.

Two sterile microneedle cartridges standing beside a clear storage case holding a third cartridge, with no brand printing visible
Cartridges are counted by pack, and packs are counted by case. The monthly number only survives the conversion when both figures are on the packing slip.

Where does the Canadian count go wrong most often?

At the boundary between a procedure and a session. A med spa that books forty-minute sessions and runs two rooms will report "eighty appointments a month" and order for eighty kits, when the rooms actually opened ninety-four because two practitioners pre-open trays for the first three patients of the day. The four-way split in the wastage table above is the fix: count openings, record why, and reconcile against bookings once a month rather than once a quarter.

Occupational guidance is a useful cross-check on that reconciliation, because it tells a room what it should have used as well as what it did use: CCOHS on needlestick injuries and the WHO infection prevention and control programme both treat sharps handling as an engineering-control question, which in practice means one container per treatment zone and a container change tied to a count rather than to a feeling.

Related reading

Turning the count into an order

The compliance log centre carries printable daily and monthly count sheets, and the log generator builds a per-room record with the fields a monthly reconciliation needs. Where a room wants its opening rate and pack configuration reviewed against its booking pattern, the institutional account enquiry page is the route for clinics and group purchasers. Reselling? become a distributor.

CliniEco Medical distributes medical consumables in Canada under MDEL #35334. This page summarises the Medical Devices Regulations (SOR/98-282) and the component standards named above, each read on 12 November 2026; the requirement that binds a specific room is the one in its provincial legislation and its own written procedure.

Frequently Asked Questions

How many kits does a med spa with 20 procedures a week use in a month?

Twenty procedures a week is about 87 a month at one kit per procedure, and about 91 with a 5 per cent opening margin. The multiplier is 4.33 because 52 weeks divided by 12 months is not 4.

Should a kit opened for a patient who then declines treatment be counted?

Yes. The sterile barrier is gone once the seal is broken, so the kit is consumed whether or not the procedure happened. Recording it with a reason code is what stops the loss from being invisible.

Is a kit the same as a device in Canada?

It is a device, and more specifically a medical device group: a collection of medical devices sold under a single name. The class comes from the components, and a needle in the kit makes it a Class II product.

Do we need an establishment licence to buy kits for our own clinic?

No. Section 44 requires an establishment licence to import or sell devices, and the exceptions include health care facilities. The distributor you buy from holds the licence, and section 44(3) puts the duty on the importer to confirm it.

Why do the case figures in different quotes not match?

Because "case" is a commercial convention with no legal definition in either country. Two suppliers can both quote one case and mean fifty and one hundred kits, so the inner box count has to be on the order.

Does the kit count change if the room also sterilizes reusable instruments?

It adds a separate count. Reusable instruments carry their own cycle and record requirements, and kit consumption is unaffected by them; the two numbers belong on the same monthly sheet but must not be added together.

Supplies this room reorders: nitrile exam gloves, 3.2 mil, 1,000 per case, pre-perforated exam table roll, 18-inch and patient bibs, 17 × 24 in, 500 per case. All of them are in the current CliniEco catalogue and orderable online.

Already working with clinics? Become a regional representative.