Which collection supplies do Canadian workplace drug testing programmes reorder?

95kPa specimen transport bag with a BIOHAZARD panel, yellow sealing flap and printed closing instructions

Which collection supplies do Canadian workplace drug testing programmes reorder?

A collection site that handles sixty donors a month rarely runs short of test devices, because the programme supplies those. What runs out is the layer underneath: the cup the donor fills, the bag it travels in, the gloves changed between donors, and the labels that keep paperwork away from the sample.

Start with the primary container. A graduated 90 mL specimen cup carries moulded marks at 20, 30, 40 and 50 mL, a screw-fit lid and a write-on panel for name, date and ID — the three fields filled in before the specimen leaves the room. Six bags of a hundred make a case, so one case is 600 collections of primary container on a shelf.

What does a Canadian collection site actually reorder each month?

Five lines carry nearly all of the volume, and each is driven by a different number. Cups and bags follow donor volume; gloves follow handling steps rather than donors.

Line Format usually stocked Unit What drives the monthly count
Primary container 90 mL graduated cup, screw lid 100 per bag, 600 per case donors, plus repeats
Secondary bag 6 x 9 inch, 95 kPa, document pouch 100 per pack one per specimen shipped
Large container 120 mL screw cap 100 per pack, 200 per case pooled or repeat samples
Gloves nitrile exam, 4.0 to 4.5 mil 100 per box, 1,000 per case donors plus handling steps
Requisition labels write-on with permanent ink sheet one per specimen

How many millilitres should a collection cup hold?

The useful fill volume sits inside the 20 to 50 mL band the cup is marked for: enough for a screening run and a retained aliquot, without inviting a donor to overfill a container that then leaks in transit.

Clear graduated specimen cup with a blue lid, graduations marked 20 to 50 mL, and NAME, DATE and ID lines on the lid

A short fill is one of the rejections a receiving laboratory reports most often, and a cup that cannot be read from the outside hides the problem until the laboratory weighs the specimen. That is why specimens get rejected for short fills: the volume was never checked in the room.

Which transport bag does a urine specimen need?

The cup is the primary container and the bag is the secondary. The 95 kPa figure describes the pressure secondary packaging is expected to hold, and the bag carries three things at once: the sealed specimen, an absorbent layer, and the request form in its own outer pouch. A 6 x 9 inch 95 kPa specimen transport bag does that in one step — specimen through the slit, flap folded at the printed line, requisition in the back pouch, paper never touching the sample.

Where a programme collects a larger volume or pools samples, a 120 mL screw-cap specimen container fits the same bag without stressing the seal, and its label carries date, room, name and specimen type.

What is the difference between a specimen cup and a drug test device?

A cup is a container; a test device is a regulated product with its own claims and paperwork. In a programme that runs a chain of custody, the tamper-evident seals, the temperature strip and the custody form come from the testing provider, not from the container supplier. That split belongs on the purchase order: the medical supplier provides the cup, the glove and the transport bag, while the programme provides the device and the custody chain.

95kPa specimen transport bag with a BIOHAZARD panel, yellow sealing flap and printed closing instructions

How many cups and bags should a site hold per 100 donors?

The ratio is a working number rather than a rule: one container per donor, one bag per specimen shipped, and a reserve of roughly one in twenty for repeats and training. Gloves run at about two pairs per donor once re-sealing is counted.

Donors a month 90 mL cups 95 kPa bags Gloves, pairs
50 100 (one bag) 100 (one pack) 110
100 200 (two bags) 200 (two packs) 220
250 300 (three bags) 300 (three packs) 550

A case holds 600 cups, so the 250-donor column is a case roughly every two months with a single bag opened in between. That is the argument for stocking in bags of a hundred: the reserve stays sealed while the working bag sits on the bench.

Where does a used collection cup go?

Ontario's C-4 guideline defines human blood waste and microbiology laboratory waste as excluding urine and feces unless visibly containing blood. A sealed cup from a routine screening therefore leaves the room as general waste, while a cup visibly contaminated with blood belongs in the biomedical stream. The handling side of that split is what CSA Z317.10:21 addresses. Over-classifying puts clean waste into a regulated stream; under-classifying puts blood where it does not belong.

Running a collection site or an occupational health service? See clinic consumables for the room-by-room list.

Ordering for a clinic, lab or care home? Wholesale and multi-site ordering covers case pricing and account setup, and the B2B wholesale collection lists the lines stocked for institutional buyers. Reselling? become a distributor.

References

  1. C-4: Management of Biomedical Waste in Ontario — Ontario Ministry of the Environment, Conservation and Parks (checked 6 November 2026)
  2. Substance Use in the Workplace — Canadian Centre for Occupational Health and Safety (OSH Answers) (checked 6 November 2026)

Printable companion: the clinic supply planner includes a printable checklist you can keep at the collection desk and fill in as the monthly count is taken.

Prefer the counts worked out from donor volume? The supply planning tool turns a monthly donor number into case quantities for cups, bags and gloves.

Related Reading

Frequently Asked Questions

How many specimen cups does a collection site use per 100 donors?

One cup per donor plus a reserve of about one in twenty for repeats, short fills and collector training. In practice 100 donors works out to two bags of 100 cups; the six-bag case covers roughly 500 donors.

Which cup size do Canadian collection sites use for a urine specimen?

The common format is a 90 mL graduated cup, read at eye level from moulded marks between 20 and 50 mL. The graduation shows the fill volume in the room, before the specimen reaches the laboratory.

Is a urine specimen cup biomedical waste in Ontario?

Under Ontario's C-4 guideline, urine and feces are excluded from human blood waste and microbiology laboratory waste unless visibly containing blood. A sealed cup from a routine screening is general waste; a cup visibly contaminated with blood is not.

Can a urine specimen travel in a plain plastic bag?

No. It needs a secondary container rated to 95 kPa with an absorbent layer and a separate document pouch. A 6 x 9 inch 95 kPa bag fits a 90 mL cup or a 120 mL container.

Last updated: November 2026. CliniEco Medical is a licensed medical device establishment (MDEL #35334).

Already working with clinics? Become a regional representative.