Short answer: The container follows the test, not the other way round. Canadian labs match a specimen cup to a midstream urine, a screw-cap container to a 24-hour collection, and a stool kit to an occult blood or culture request, because volume, sterility and the transport rule each change which container is acceptable. A general 90 mL cup is not a substitute for a sterile screw-cap container when the test requires sterility.
Start from our
graduated 90 mL leak-proof specimen cup, 100 per pack for routine collection volumes, and move to the 120 mL sterile screw-cap container where the test calls for a sterile primary container.
Which specimen container fits which Canadian lab test?
Four families cover most requests in a Canadian collection site. The table below is the short version; the sections after it explain the two rules that cause most rejections.
| Test | Container | Typical volume | What matters |
|---|---|---|---|
| Routine urinalysis | Graduated cup, screw lid | 90 mL | Leak-proof lid, graduation readable |
| Urine culture | Sterile screw-cap container | 120 mL | Sterile interior, no preservative unless specified |
| 24-hour collection | Large screw-cap container | 2 to 3 L | Volume capacity and a label that survives the period |
| Stool culture or occult blood | Stool collection kit | Kit-defined | Integral spoon, tight seal, no leakage in transport |
| Transport to another site | 95 kPa secondary bag | Bag-defined | Pressure rating and a separate document pouch |
Why does sterility change the container choice?
A sterile container protects the sample from organisms introduced at collection, which matters for culture-based tests. A clean but non-sterile cup is adequate for a routine urinalysis where the question is chemistry rather than growth, and it costs less. Substituting one for the other in either direction creates a problem: a non-sterile cup for a culture can produce a false positive, and a sterile container for a routine screen wastes money on every sample.
Read the requisition rather than the habit of the room. Where the request names a culture, use the sterile screw-cap container even if the volume is identical to the routine cup.
What volume does a urine container actually need?
Most routine requests are satisfied by 50 mL or more of sample, so a 90 mL cup with a readable graduation gives room to fill without overfilling. A 120 mL sterile container is chosen for the sterile interior rather than for the extra volume; do not assume the larger number means a fuller sample is needed.
For a 24-hour collection the constraint is total volume across the period, not per-void volume. A 2 to 3 L container avoids a mid-collection transfer, and a transfer is where most 24-hour collections fail through spillage or mislabelling.
How should a specimen container be labelled?
- Patient identifiers on the container itself, not only on the bag.
- Collection date and time written at the point of collection.
- Container type recorded, so the lab knows whether the primary container was sterile.
- Requisition in its own pouch, never inside the specimen bag with the container.
Label the container before collection, not after. A label applied to a filled container sits on condensation and can lift in transit, and an unlabelled or partly labelled primary container is a rejection regardless of sample quality.
When does a specimen need a 95 kPa secondary bag?
Any specimen leaving the building for another site travels in a secondary bag rated for the pressure differential the packaging has to survive, with absorbent material around the primary container. That is the UN3373 Category B packaging approach, and it applies to courier runs between a collection site and a reference lab as much as to air transport.
Which container mistakes cause the most rejections?
Three, in practice: the wrong container for a culture, an overfilled container that leaks at the lid, and a requisition packed inside the bag with the specimen. Each is avoidable at the bench, and each costs a repeat collection. A short checklist at the collection station catches all three before the courier arrives.
Does the container change for a paediatric or veterinary sample?
Yes, in volume rather than in type. Smaller collection volumes still need a container the lab can process, and a paediatric urine sample in an adult-sized cup is harder to handle and easier to spill. Keep a small-volume format on the shelf alongside the standard cup so staff do not improvise with a bag.
Related Reading
For transport bag selection, read 95 kPa specimen bags versus 3-wall transport bags. For labelling, see specimen bag labelling in Canada, and for the current guidance read Canadian specimen transport guidance changes.
Ordering for a clinic, lab or care home? Wholesale and multi-site ordering covers case pricing and account setup, and the B2B wholesale collection lists the lines stocked for institutional buyers. Reselling? become a distributor.
Use the specimen container type reference at the collection bench and the printable collection and transport log for each courier run. Need a mixed quote across cups, screw-cap containers and transport bags? Request a bulk quote or ask a compliance specialist.
Related Reading
- 95 kPa specimen bags versus 3-wall transport bags
- Specimen bag labelling in Canada
- Canadian specimen transport guidance changes
- Specimen container type reference
Frequently Asked Questions
What container is used for a urine culture in Canada?
A sterile screw-cap container, because the test depends on detecting growth and a non-sterile cup can introduce organisms. A routine urinalysis that only asks chemistry questions can use a graduated non-sterile cup.
Can a 90 mL cup be used for a 24-hour urine collection?
No. A 24-hour collection needs a container sized for the total volume across the period, commonly 2 to 3 L. Using a small cup forces a mid-collection transfer, which is where most 24-hour collections are lost.
Where does the requisition go when a specimen is bagged?
In its own document pouch, separate from the specimen container. Placing paperwork inside the bag with the sample risks contamination of the requisition and is a common reason for rejection at the receiving lab.
Does every specimen need a 95 kPa transport bag?
Any specimen that leaves the building should travel in a secondary bag rated for the pressure differential, with absorbent material around the primary container. That applies to local courier runs as well as to air transport.
CliniEco Medical is a licensed medical device establishment (MDEL #35334).