Storing and Labelling Protégé Nitrile Exam Gloves in Ontario and Quebec Clinics: Expiry and Record Rules

A single sky-blue nitrile examination glove laid flat on a white background, showing the textured fingertips and the beaded cuff

A case of Protégé exam gloves arrives with a label the clinic did not write, and it leaves the shelf because of a rotation rule the clinic did write. The label answers to federal law. The shelf, the receiving record and the monthly check answer to the clinic. Ontario and Quebec add their own layer beyond the federal one, and the gaps that turn up in a walk-through usually sit in the clinic's own layer rather than on the printed label.

The case these rules are written around is the Protégé nitrile exam gloves, 4.0 mil, 1,000 gloves per case: ten dispenser boxes of 100, one size per case, S to XL.

What has to appear on the label of a Protégé exam glove case?

Section 21(1) of the Medical Devices Regulations says that no person shall import or sell a medical device unless the label sets out a defined list, from the name of the device through to any special storage conditions. Two paragraphs of that list decide how a glove case is read.

Paragraph (g) requires "the expiry date of the device, if the device has one, to be determined by the manufacturer on the basis of the component that has the shortest projected useful life". Paragraph (j) requires "any special storage conditions applicable to the device". Paragraph (d) is the one buyers misread: it requires the control number, which is the lot number, only "in the case of a Class III or IV device", so for a glove the control number is a manufacturer practice rather than a paragraph 21(1)(d) obligation. Subsection 21(2) adds that the information must be expressed in a legible, permanent and prominent manner. The film itself is bought against ASTM D6319, the specification for nitrile examination gloves, with watertightness measured through the D5151 test, and the 4.0 mil case in this range is listed as medical grade and chemotherapy tested.

Health Canada's notice on medical gloves states the classification that sits behind the label: "Medical gloves are classified as Class II devices. This is the case whether the gloves are made of latex, vinyl, synthetic polymer or nitrile, or are sterile or non-sterile." The same notice says that "you cannot import or sell a Class II medical device unless the manufacturer has a medical device licence from Health Canada", and that a label has to make the medical use clear using words such as health care, examination, patient examination, sterile or medical grade.

Paragraph of section 21(1) What it requires Where the clinic sees it
(a) to (c) Device name, manufacturer name and address, device identifier Front and end panels of the dispenser box
(d) Control number only for a Class III or IV device Not a glove obligation; the lot number is printed as manufacturer practice
(e) Contents where not readily apparent, such as size and number of units The size letter and the 100-glove count on the front panel
(f) The word Sterile where the device is sold sterile Absent on a non-sterile exam glove, which is itself informative
(g) Expiry date if the device has one, set from the shortest-lived component The date printed on the box or case, when the maker assigns one
(h) Intended medical use and performance specifications where needed Words such as examination and medical grade
(i) Directions for use Enclosed leaflet or the panel text
(j) Any special storage conditions The storage line the clinic is obliged to follow
A single sky-blue nitrile examination glove laid flat on a white background, showing the textured fingertips and the beaded cuff

Who sets the expiry date, and what does the clinic do with it?

The date comes from the manufacturer, and the regulation explains why: it is set on the basis of the component with the shortest projected useful life, which is a stability decision made by the party that validated the product, not a decision the clinic or the distributor can revisit. The clinic's obligation is narrower and harder to evidence, which is that the product was used within the life the manufacturer set and was stored the way paragraph (j) requires.

Storage is where paragraph (j) becomes an operational instruction. A glove case that sits against a radiator, in a south-facing window or in a vehicle over a weekend has been stored outside the conditions on its own label, and the expiry date no longer describes it. A clinic that keeps the case in a closed cupboard at room temperature, in date order, and writes the received date on the carton has satisfied both the storage condition and the rotation that follows from it.

One practice is ruled out rather than advised against. Public Health Ontario's infection prevention and control guidance for clinical office practice, in its second revision dated November 2026, tells staff to remove gloves and discard them immediately after the activity, and states plainly: "Do not re-use or wash gloves." A washed glove has no declared useful life left to measure, so a clinic cannot extend a case by reprocessing it. A chemotherapy claim is a separate piece of evidence from the wall thickness: ASTM D6978 is the standard reference for cytotoxic permeation testing, and the report behind the claim is the document to ask a supplier for.

Two sky-blue nitrile examination gloves lying side by side on a white surface, cuffs open and fingers pointing upward

Do Ontario and Quebec clinics store and label gloves the same way?

The clinical rules converge and the language rules do not. In Ontario, the employer's duty is the general one in the Occupational Health and Safety Act, section 25(2)(h), to take every precaution reasonable in the circumstances for the protection of a worker, and the operational detail is supplied by Public Health Ontario. Its routine practices guidance, published under Public Health Ontario's infection prevention and control topic pages, is explicit that "gloves are task-specific and single-use for the task" and that re-use has been associated with transmission of methicillin-resistant Staphylococcus aureus and Gram-negative bacilli. The clinical office checklist goes one step further and asks, once a month, whether personal protective equipment is available, accessible and in good condition, which is the only routine in the pair that inspects a stored case.

Quebec adds a language requirement that reaches past the manufacturer's box. Section 51 of the Charter of the French language provides that every inscription on a product, on its container or on its wrapping, or on a document or object supplied with it, including the directions for use, must be drafted in French, and that a translation may accompany it but no inscription in another language may be given greater prominence than the French one. A glove box is a container, and an instruction card or wall poster the clinic prints about glove use is a document supplied with the product, so the French requirement lands on material the clinic produces itself, not only on what Aurelia printed. The provincial infection control references that Quebec clinics work from, including the provincial prevention and control guide and the standards and good practices document from the CIUSSS de la Capitale-Nationale, carry the same single-use message as Ontario's material.

Item Ontario Quebec
Clinical glove rule Single use for the task, discarded immediately after the activity Same single-use rule in the provincial prevention and control references
Storage condition Set by the manufacturer's label under section 21(1)(j) Same, plus the French inscription rule on documents supplied with the product
Language on a clinic-made instruction card No provincial requirement beyond the federal minimum French required, with translations permitted but not more prominent
Routine inspection of stored stock Monthly clinical office checklist, including whether protective equipment is in good condition Covered by the clinic's own infection prevention and control procedures

How does glove labelling differ between Canada and the United States?

The classification differs before the label does. A patient examination glove in the United States is described at 21 CFR 880.6250 as "a disposable device intended for medical purposes that is worn on the examiner's hand or finger to prevent contamination between patient and examiner", and it is placed in Class I, general controls. The premarket notification exemption written into that section is limited to finger cots, subject to the limitations in section 880.9, which is why an examination glove's United States history is a clearance file under the premarket notification procedures in Part 807, subpart E rather than an exemption letter.

In Canada the same object is a Class II device, and the licence sits with the manufacturer rather than with the clinic that buys the case. That produces a practical asymmetry: a case bought from a United States catalogue can carry a label that is entirely correct for that market and still not satisfy section 21(1) here, and the party that has to fix it is the importer, not the clinic.

Item Canada United States
Risk class of a patient examination glove Class II Class I under 21 CFR 880.6250
Who holds the authorisation Manufacturer holds the medical device licence Pre-market clearance file held by the manufacturer, with the exemption in that section limited to finger cots
Device identifier on the label Required by section 21(1)(c) Required under the unique device identification rule
Language on the professional label English or French as a minimum, both for sale to the general public English
Test standard cited by buyers ASTM D6319, nitrile examination gloves ASTM D6319 as well, alongside the product code listing

Do clinics in Canada and the United States keep the same glove records?

Neither country imposes a glove-specific record on the clinic itself, and both expect the storage condition to be demonstrable. On the United States side the record is part of the bloodborne pathogens standard: 29 CFR 1910.1030 requires disposable gloves to be "replaced as soon as practical when contaminated or as soon as feasible if they are torn, punctured, or when their ability to function as a barrier is compromised", states that disposable gloves "shall not be washed or decontaminated for re-use", and requires equipment that is removed to be placed in an appropriately designated area or container for storage, washing, decontamination or disposal.

The Canadian equivalent is assembled from guidance rather than from one clause: the storage condition on the label, the single-use rule in the provincial guidance, and the clinic's own monthly check. The working minimum that satisfies both systems on one page is a receiving line for the date, lot and size, a shelf location named once and not changed, the initials of the person who ran the monthly check, and the date the last case was opened.

How many cases should a clinic hold, and how is stock rotated?

The arithmetic is short. Thirty patient contacts a day over five days is 150 contacts a week, and at two gloves per contact that is 300 gloves, so a 1,000-glove case covers a little over three weeks for one busy room. Holding one open case and one sealed case gives roughly seven weeks of cover, which is enough to absorb a late delivery without turning the storage cupboard into a warehouse with its own expiry problem.

Rotation follows the date, not the stack order. New cases go behind, the received date goes on the carton in marker, and the monthly check ends with the earliest date at the front. Where the room does short examination contact rather than wound work, the same thousand-glove case build is available in a lighter film: the Transform 100 nitrile exam gloves, 3.2 mil, 1,000 gloves per case uses the same ten-box packing, so the rotation rule above does not change.

Because the case carries a single size, a clinic that stocks M and L rotates two stacks, and the size that runs out first is the one whose reorder point should be reviewed rather than the one that gets a second stack squeezed into the same drawer.

Related reading

Frequently asked questions

Does an exam glove case have to show an expiry date in Canada?

Only if the manufacturer assigns one. Section 21(1)(g) of the Medical Devices Regulations requires the expiry date "if the device has one", set from the component with the shortest projected useful life. Where a maker assigns no date, the storage condition in paragraph (j) carries the weight instead, and the clinic's record has to show that the condition was met.

Can a clinic keep using a case after the printed date if the gloves look fine?

No. The date is the usable life the manufacturer established, and appearance is not a test of film integrity. The case is removed from the shelf, the removal is written down with a date, and the reason is recorded so the next rotation check does not repeat the question.

Is a case labelled for the United States acceptable in an Ontario clinic?

Not on its own. Canadian labelling requirements apply to devices sold here, and the importer is the party responsible for meeting them. A clinic that buys from a foreign catalogue should ask for the Canadian label, the manufacturer's licence details and the storage condition before the case enters the cupboard.

Does a Quebec clinic need French on its own glove posters?

Yes, where the poster or card is supplied with the product. Section 51 of the Charter of the French language covers inscriptions on a product, its container and its wrapping, and on documents supplied with it, including directions for use. A translation may sit alongside the French, but it may not be given greater prominence.

Can gloves be washed and reused to reduce waste?

No. Public Health Ontario's clinical office practice guidance says not to re-use or wash gloves, and the United States bloodborne pathogens standard says disposable gloves shall not be washed or decontaminated for re-use. A washed glove has no declared useful life left, so there is nothing left to date.

What should be written on the carton when a case is opened?

The date it was opened and the initials of the person who opened it. That single line, next to the printed expiry date, is what turns a storage decision into a record, and it is the field most often missing when a walk-through asks how long the open case has been in the cupboard.

Where does the lot number on a glove box come from, if section 21(1)(d) does not apply?

From the manufacturer's own system and from the device identifier required by section 21(1)(c). The control number paragraph is written for Class III and Class IV devices, so a glove box still carries a lot for traceability and for complaint handling, but its presence is not the evidence that paragraph (d) was met.

Keeping the storage record without adding paper

Three pages carry the record side of this article. The compliance log centre holds a free sterilization log sheet generator that clinics already print for their reprocessing cycles, and the clinic supply and cost planner turns an order pattern into a quarterly schedule. Clinics that want the glove and instrument consumables on one standing order start from the institutional account enquiry page, and a clinic documenting glove and reprocessing practice together can use the sterilization compliance consultation route. Reselling? become a distributor.

CliniEco Medical distributes clinic consumables in Canada under MDEL #35334. This article describes requirements published by Health Canada, the Government of Ontario, the Government of Quebec and the United States federal register; the requirement that binds a specific clinic is the one in its provincial guidance, its accreditation conditions and its own written procedure.

Already working with clinics? Become a regional representative.