Shift Handover for Biological Indicators: What Must Be Passed On
At seven in a care home with one sterilizer, the outgoing shift has three things in flight: a load released that morning, an indicator incubating since two, and a tray waiting for morning. The handover sheet records the first and forgets the second. That is the gap auditors find, and how an unreleased load reaches a resident.
The 24-hour biological indicator, 25-pack is the format most single-sterilizer sites run, and its incubation window makes the handover unavoidable: a result returning fourteen hours after the cycle always crosses a shift.
What must cross the shift line about a biological indicator?
Four things, in this order of risk. The time incubation started, because every later question depends on it. The reader — incubator or fluorescence reader — with the well position. The indicator's lot number and expiry, printed on the vial and pack. And the loads still held, listed one by one, because a hold recorded as a sentence gets released by accident.
A paragraph about the day and none of these four hands nothing over.

Which fields belong on the handover sheet?
| Field | Why the next shift needs it | Where it is recorded |
|---|---|---|
| Sterilizer and cycle number | Ties the indicator to the load it clears | Cycle log |
| Indicator lot and expiry | A recall or a failed lot is traced from these two | Pack label and record |
| Incubator or reader ID, well position | Two machines in one building cannot be told apart by result alone | Incubator log |
| Incubation start time, read time and who read it | The start sets when the result is due; the signature attaches authorisation to a name, not a shift | Record, written at the time |
| Loads still held | The only field a clinician at the shelf will act on | Hold tag on the load and the record |
The incubator log and the load record are two documents; the handover links them, and a site keeping one without the other can name the result but not the load.
What changes when the result comes from a reader instead of an incubator?

A fluorescence reader returning a result in an hour or three compresses the window, not the paperwork. Traceability moves: the reader stores a well position and a timestamp, and the handover carries those two instead of an incubation start. The halt rule does not change — a positive result holds every load in that cycle, and the hold crosses the shift with the record. Sites running both formats keep one sheet with a readout column; two sheets is how a result lands in the wrong place.
Who may release the load, and what does the handover say about it?
The person authorised in the facility's policy, by name, with the time. If that person is not on the incoming shift, the handover must say who is, or the load waits. That is where a handover stops being administrative: a named person is what makes the release defensible months later.
Multi-shift care homes running a daily indicator programme need the incubator, the indicators and the log in one system of record. The 1-hour rapid-readout indicators, 50-pack shorten the window above, the 24-hour incubator reads the 24-hour format, and the long-term care supplies range covers the rest of the set.
Ordering for a clinic, care home or multi-site group? Wholesale and multi-site ordering covers case pricing and account setup, and the B2B wholesale collection lists the lines stocked for institutional buyers. Reselling? become a distributor.
TSA:
Printable companion: the sterilization log sheet lays out the same fields in the order a handover is written, so the outgoing shift fills one page instead of composing a message.
TSB:
Want the columns printed for your own cycle type? The sterilization self-check walks the record backwards from the result and flags the field that is missing.
STERILE: 1
References
- Medical Devices Regulations (SOR/98-282), section 44 — establishment licence requirement (checked 18 November 2026)
- Health Canada, Medical Devices Establishment Licence (MDEL) Listing (checked 18 November 2026)
Not sure how this applies to your own setup? Ask a sterilization compliance specialist — you’ll get a written answer specific to your equipment and province, with the regulation or standard cited.
Related Reading
- What an Auditor Asks About Your BI Incubator: The Five Records That Prove Compliance
- Fluorescence Auto-Reader Audit Trail: What Must Be Documented After Every Load
Frequently Asked Questions
Can a shift hand over a biological indicator that is still incubating?
Yes, and that is the normal case. What crosses the shift line is the incubator or reader identifier, the well position, the lot number and the exact time incubation started, so the next shift knows when the result is due.
How long does the load stay held if the result is not back?
Until the result is read and recorded. A load cannot be released because a shift ended, and the hold has to be visible on the load itself, not only in the record, so a clinician at the shelf sees it.
Does a 1-hour reader change what the handover carries?
It shortens the window, not the fields. With a fluorescence reader the well position, the reader identifier and the read time become the traceable items, because the reader produces the result rather than the incubator.
Last updated: November 2026. CliniEco Medical is a licensed medical device establishment (MDEL #35334).