A 20 L Ultrasonic Cleaner Is a Station, Not a Bench Unit: When a Clinic Needs One

Stainless steel ultrasonic cleaning tank with a wire instrument basket suspended above the tank floor

A 20 L Ultrasonic Cleaner Is a Station, Not a Bench Unit: When a Clinic Needs One

A 20 L tank does not look much bigger than a 6 L one in a photograph. On a bench it changes what the room does: the bench carries roughly 37 kg, someone has to be able to reach the drain valve, and the cycle stops being a step in a routine and becomes a station that instruments arrive at in batches.

The unit we stock in that role is the CliniEco CS20 ultrasonic cleaner — 20 L chamber, eight transducers, 500 W ultrasonic and 500 W heating, fitted drain valve. What follows is the specification that matters, the arithmetic that decides whether the size is right, and the daily routine a tank this size imposes.

What does the CS20 actually specify?

Item Specification
Tank capacity 20 L, chamber 42 × 26 × 20 cm
Transducers 8, distributed across the tank floor
Ultrasonic power 500 W
Heating 500 W
Power per litre of nominal capacity 25 W per litre
Unit dimensions 54 × 37 × 40 cm
Weight 17 kg net, 20 kg gross, plus about 20 kg of water in use
Installation Bench or recessed into a counter
Supply AC 100–120 V, North American plug
Drain Front drain valve

Eight transducers across the floor is the specification that decides whether a 42 cm chamber cleans evenly: a single transducer in the middle of a tank this length leaves a weak zone at each end, which is exactly where long-handled instruments sit.

What changes when the tank reaches 20 L?

Three things change at once, and only one of them is about cleaning. The first is the load: a 42 cm chamber takes a full cassette lying flat, plus loose instruments around it, without stacking. The second is the bench: about 37 kg with water in it, which is more than a typical treatment-room counter is intended to carry at a single point. The third is the routine, because emptying a 20 L tank into a jug is not a task anyone wants to do twice a day, which is why the drain valve is not a convenience feature on a unit this size.

CliniEco CS20 20 L benchtop ultrasonic cleaner, stainless steel tank with digital timer and heater and a front drain valve

The practical pattern is a dedicated station: a counter length reserved for the tank, a drain that reaches a sink or container without lifting the unit, and instrument flow arranged so dirty instruments arrive from one side and clean ones leave the other. A 20 L tank placed where a 6 L tank used to sit ends up half full and used like a small unit.

Does a bigger tank clean better?

No. It cleans more at once, and that is a different claim. The comparison that settles it is power against volume: 500 W across 20 L is 25 W per litre of nominal capacity, while the CS8.0 8 L unit at 450 W works out at about 56 W per litre, and closer to 64 W per litre against its 7,000 ml working volume. Cavitation energy per litre is lower in the larger tank, not higher.

So a 20 L tank is the right answer for a load that is large, awkward in shape, or arriving in batches that have to move through together. It is the wrong answer for a load that is heavily soiled and small: the fix there is longer cycles and better positioning, not a bigger machine.

Solution volume matters in the same direction. A 20 L fill of a low-foam multi-enzyme concentrate at a 1:400 to 1:600 dilution takes roughly 33 to 50 ml of concentrate per fill, which is four to five times what a 4 L tank draws. That is a running cost and a stock decision, not a cleaning advantage.

How does a 20 L unit change the daily routine?

Stainless steel ultrasonic cleaning tank with a wire instrument basket suspended above the tank floor

The steps are the same as any ultrasonic bath, and the volumes make them more deliberate. Fill to the working level rather than the rim, because a full tank overflows when a loaded cassette displaces water. Measure the concentrate rather than estimating it. Let the heater reach its set point before the first load. Degas a fresh fill, because mixing solution entrains gas and gas cushions cavitation. Keep everything in the basket, never on the tank floor.

Then the end of the day: follow the detergent maker's stated reuse period, drain before a weekend or shutdown, and rinse the tank before it dries. On a 20 L unit the drain is the step that gets postponed, and a tank left full and warm over a weekend comes back with a film that topping up will not fix.

When is a 6 L or 8 L unit still the right size?

Most single-location dental practices never need 20 L. A 6 L class tank such as the CS6.2, dual frequency 32 and 48 kHz, takes a full instrument cassette in one cycle, which is where most clinics stop needing more capacity. An 8 L tank takes two chairs' instruments in a single cycle, which is the step for a busier practice with a fixed morning load.

A 20 L tank earns its place when the load is not made of cassettes: long-handled instruments, trays, a laboratory, or a clinic that has moved reprocessing into one room serving several operatories. If the daily load is four cassettes and a handful of handpieces, a smaller unit cleans it with more power per litre and less bench space.

What should a 20 L installation check before delivery?

The bench rating, the route from the tank to the drain, the electrical supply, and the paperwork that has to exist on day one. Canadian clinics are expected to follow CSA Z314:23 for reprocessing, and provincial guidance such as Public Health Ontario's cleaning, disinfection and sterilization practices describes the cleaning step the tank performs. The instrument manufacturer's instructions, as required by ISO 17664-1:2021, decide what may go into the tank at all.

A clinic running several operatories, or a laboratory processing for more than one practice, can also open a wholesale and institutional account for case pricing and purchase-order billing. None of that changes with tank size. The rest of the range sits together in ultrasonic cleaners and enzyme solution, with the tank sizes side by side. Reselling? become a distributor.

References

  1. CSA Z314:23, Reprocessing of medical devices in all health care settings (checked 19 November 2026)
  2. Public Health Ontario, cleaning, disinfection and sterilization practices in all health care settings, 3rd edition (2013) (checked 19 November 2026)
  3. Public Health Ontario, Infection Prevention and Control Checklist — Dental Core (checked 19 November 2026)
  4. ISO 17664-1:2021, Processing of health care products — information to be provided by the medical device manufacturer for the processing of medical devices (checked 19 November 2026)
  5. Canada, Medical Devices Regulations SOR/98-282, section 44 (establishment licence) (checked 19 November 2026)

Printable companion: the printable reprocessing log sheets carry the fill, solution-change and drain columns described below, so a 20 L tank gets the same written record as a benchtop unit.

Working out what a 20 L tank draws in a year? The clinic supply planner converts fills per week into concentrate volumes, so the order matches the workload rather than the shelf.

Related Reading

Frequently Asked Questions

How many instruments fit in a 20 L tank?

More than most clinics load at once, which is the point. The chamber is 42 cm long, so a full cassette lies flat with room to spare and loose instruments can be laid around it without stacking. Stacking is where cleaning fails, so floor area is what earns the size.

Does a 20 L tank clean better than a 6 L tank?

No, and the arithmetic says why. Power is 500 W across 20 L, which is about 25 W per litre of nominal capacity, against 450 W across 8 L on the CS8.0, which is about 56 W per litre. A larger tank spreads its power thinner, so the load has to be positioned rather than crowded, and heavy soil still needs the cycle time it needs.

How heavy is a 20 L unit in use?

The unit is 17 kg dry and about 20 kg gross, and a full tank adds roughly 20 kg of water, so the bench carries around 37 kg. That figure decides installation: a counter rated for a benchtop unit may not be the right place, which is why these units are often recessed or set on a trolley.

Can I drain a 20 L tank into a regular sink?

Check the local sewer discharge rules before the first drain, because the answer depends on the chemistry you use, not on the volume. What can be stated plainly is the plumbing side: the drain valve is fitted at the front, and the tank needs to be low enough for a container or a hose run to a sink without lifting the unit.

What documentation should a 20 L setup keep?

The same records as any other tank: solution product and dilution, fill date, working temperature, cycle count, drain and cleaning date. Provincial guidance expects the cleaning step to follow the instrument manufacturer's validated instructions, and CSA Z314:23 sets out the reprocessing requirements involved.

Last updated: November 2026. CliniEco Medical is a licensed medical device establishment (MDEL #35334).

Already working with clinics? Become a regional representative.