Autoclave spore tests in Ontario are bought as single-use biological indicators, ordered in packs sized to one sterilizer's daily monitoring rather than to a calendar week. The supplier question that matters is not who quotes the lowest unit number on a 50-pack; it is whether the lot arrives with the control result, the expiry date and the incubator handling your log has to show. Start from the
24-hour self-contained biological indicators format most Ontario clinics run, then size the order to your cycle volume.


How often does an Ontario clinic actually use a spore test?
The RCDSO infection prevention and control standard requires a biological indicator for each sterilizer on every day the sterilizer is used, and for each type of cycle used that day. That is daily monitoring, not weekly. The weekly baseline that circulates online is the CDC and AAMI ST79 position used in most US states, and copying a weekly schedule into an Ontario clinic is the single most common documentation gap we see in pouch and log reviews.
Practical effect on ordering: a clinic running five treatment days a week with one steam cycle type needs roughly 250 indicators a year before waste and repeats, not 52. Two cycle types in use on the same day doubles the daily count. That arithmetic is what turns a 50-pack into the wrong unit of purchase.
Which pack size should a single-surgery clinic order?
| Setting | Daily BIs | Annual units | Sensible first order |
|---|---|---|---|
| Single chair, steam only, 5 days | 1 | ~250 | Two 50-packs, reorder at 60 units |
| Two sterilizers, steam only | 2 | ~500 | Four 50-packs, monthly top-up |
| Steam plus a second cycle type | 2-4 | 500-1,000 | Ten 50-packs, quarterly |
| Multi-site group | Per site | Per site | Site-level par, one group account |
Sizing by "we order when the box looks low" fails because the reorder point lands after the stock is already short. Set a par level, not a habit: two weeks of use plus one spare pack per sterilizer.
What should you confirm with a spore test supplier before ordering?
- Lot number and expiry printed on the individual vial, not only on the carton.
- A control result with the same lot, so the log entry can show the control was read alongside the test.
- Incubation temperature and readout time stated in the instructions, matched to the incubator you own.
- Whether the format is self-contained, because a spore strip needs a separate recovery step your staff may not have been trained on.
- Lead time in writing, and whether partial shipments are possible when a second sterilizer comes online.
How do lead times behave for Ontario buyers?
Stocked Canadian lines normally reach an Ontario address in days, not weeks, and the constraint is usually paperwork rather than freight: a new clinic account needs the shipping address, the receiving contact and the purchase order format before the first shipment clears. Multi-site groups should ask for one account with site-level ship-to records instead of one account per office, otherwise every reorder restarts the setup.
What does the receive-and-store step involve?
Biological indicators are temperature-sensitive. Store them at the range printed on the insert, keep the carton closed until use, and do not park a spare box in the sterilizer room where radiant heat can sit above room temperature. First in, first out, and write the lot on the log at the moment of use rather than at month end.
Printable layer: the sterilization log center holds the printable daily spore test log, and the same page runs a log generator for clinics that record on screen.
Need a second opinion on your monitoring schedule? Ask a Compliance Specialist and bring your current log to the conversation.
Ordering for a clinic, lab or care home? Wholesale and multi-site ordering covers account setup and case formats, and the B2B wholesale collection lists the lines stocked for institutional buyers. Reselling? become a distributor.
Related reading
- How many spore tests a clinic needs per year
- When a spore test comes back positive
- First order sizing for a new clinic
Frequently Asked Questions
Does Ontario require a spore test every day?
Yes. The RCDSO standard requires a biological indicator for each sterilizer on each day it is used, and for every type of cycle used that day. Weekly spore testing is the CDC and AAMI ST79 baseline in most US states, not the Ontario requirement.
How many biological indicators does a one-surgery clinic need per year?
A clinic that sterilizes five days a week with a single steam cycle needs about 250 indicators a year, plus a margin for repeats and failed runs. Two cycle types in daily use doubles that figure.
What should be printed on the indicator itself?
Lot number, expiry date and the readout time for the incubation temperature. A lot number that appears only on the outer carton makes a log entry impossible to trace during an inspection.
Do spore tests need a control result in the log?
Yes. The log should show the control read with the same lot alongside the test result, the incubator temperature, the readout time and the initials of the person who read it.
Can a clinic order spore tests once a year?
Annual ordering is possible but risky: indicators have a shelf life, and a year of stock can expire before it is used. Two to four deliveries a year, sized to a par level, keeps the lot on the shelf inside its dating.
CliniEco Medical is a licensed medical device establishment (MDEL #35334).