How to Inspect Biological Indicators on Receipt: A Receiving Checklist for Clinics

CliniEco 24-hour dry-block incubator used with self-contained indicators

How to Inspect Biological Indicators on Receipt: A Receiving Checklist for Clinics

A spore test is the smallest purchase in the reprocessing room and the only one that can void a week of release decisions. Nothing on the box reveals a night on a loading dock at -20 °C, so the first honest look happens at the door.

The 24-hour self-contained biological indicator, 50 per box is the format this checklist covers: Geobacillus stearothermophilus spores in a sealed vial, with a glass ampoule of recovery medium crushed before incubation.

What should I check on the carton before I sign for it?

Five points, ninety seconds: a dry square carton, a count that matches the slip, lot and expiry on the inner box rather than the sleeve, nothing rattling, and somewhere dry for the stock to live.

CliniEco 24-hour indicator pack Accept when Flag when Recorded in
Outer carton Dry, corners square Damp, crushed tape Slip, dated
Count Matches slip, e.g. 50 Short, or bag opened Slip with lot
Lot and expiry Legible on inner box Sleeve only Log, same day
Vials Caps seated, no rattle Cracked plastic, media visible Quarantine note
Storage fit Dry cupboard, room temperature Only spot is a fridge SOP location

Two rows carry the weight. Lot and expiry decide whether a result three weeks out can be defended; storage fit decides whether the spores survive the wait. A frozen vial separates and will not grow, which reads on the log as a cycle failure that never happened.

How do I verify a new lot before it goes into service?

CliniEco 24-hour self-contained biological indicators, 50 per box

Incubate one unexposed indicator from the lot beside the first test vial and label it the control. That step is what makes a positive result on day one a sterilizer problem rather than a bad shipment. The CDC dental guidelines treat biological monitoring as the confirmation a cycle worked; the control is what makes it interpretable. Write the control beside the test result, on the same line, so a reviewer sees that the spores were alive and the load still passed.

What does a 24-hour format need that a rapid-readout format does not?

An incubator holding 56 to 60 °C for a full day — a dry-block incubator for 24-hour indicators covers a single-unit practice — and willingness to hold the load until the answer exists. Read by colour change in the recovery medium, it needs no reader warm-up and no software version; the trade is time.

Ontario expects one indicator per sterilizer on every day the unit is used. A clinic that releases at close loses nothing to a 24-hour format if the indicator rides with the first load; one that releases within the hour belongs on a 3-hour rapid readout indicator.

How should the indicators be stored?

In the closed original box, dry, 15 to 30 °C, away from the wall above the sterilizer. Never in a refrigerator: condensation inside a cap changes what grows. One box open at a time, oldest lot first, so no more than a week of vials sits loose on a shelf.

CliniEco 24-hour dry-block incubator used with self-contained indicators

A practice running a steam unit and a dry-heat unit keeps separate cartons, because a shared tray invites the wrong vial into the wrong cycle.

What goes into the receiving record?

Five fields: date received, lot, expiry, quantity, and who checked. Add the storage location where there is more than one stockroom. Those five make a positive result traceable in minutes rather than reconstructed from memory, and they are what gets asked for when a lot is questioned.

Dental practices, walk-in clinics and care homes receive the same carton; what differs is the handling after the door.

Ordering for a clinic, a lab or a care home? Wholesale and multi-site ordering covers case pricing and account setup, and the B2B wholesale collection lists the lines stocked for institutional buyers. Reselling? become a distributor.

TSA:

Printable companion: the spore test log sheet carries a receiving block, so the lot number is captured at the door.

TSB:

See where a lot sits in your own record with the sterilization self-check, which names the missing field.

STERILE: 1

References

  1. CDC — Guidelines for Infection Control in Dental Health-Care Settings, MMWR 52(RR-17) (checked 18 November 2026)
  2. Medical Devices Regulations (SOR/98-282), section 44 — establishment licence (checked 18 November 2026)

Not sure how this applies to your own setup? Ask a sterilization compliance specialist — you’ll get a written answer specific to your equipment and province, with the regulation or standard cited.

Related Reading

Frequently Asked Questions

Can I sign for a spore test delivery and open it a week later?

Open it the day it arrives. A crushed carton or a loose cap is a delivery problem the carrier still owns that week; later it becomes yours.

Do I incubate a control from every new lot?

Yes. An unexposed indicator from the lot goes in beside the test vial, so a positive reads as a failed cycle and not as a bad shipment.

What temperature does a 24-hour indicator need?

56 to 60 °C for the full 24 hours in a dry-block incubator. The ledge above the unit is not an incubator.

Last updated: November 2026. CliniEco Medical is a licensed medical device establishment (MDEL #35334).

Vous travaillez déjà avec des cliniques ? Devenez représentant régional.