How to Inspect Ultrasonic Cleaning Solution on Receipt: A Receiving Checklist for Clinics
A pail of ultrasonic concentrate is one of the few consumables in a clinic that arrives with chemistry on the label and almost nobody checking it. It gets signed for at the back door and opened weeks later, when the bath is drained. If the label disagrees with the order, that is found mid-cycle, with a load already out of the bath.
The item this checklist is built around is the multi-enzyme ultrasonic cleaning concentrate, low-foam, dosed at 1:400 to 1:600 and supplied in a 1 L bottle or a 5 L pail. Everything below takes about three minutes at the receiving bench.
What five items decide whether you sign for the delivery?
The dilution range, the lot number, the expiry date, the pack size against your tank, and the condition of the pail.
How do you check the dilution figure against your own tank?

Working solution is the number that matters. At 1:400 a 5 L pail makes about 2,000 litres, and a 6 L dual-frequency bath takes about 15 mL of concentrate per fill: roughly 333 fills from the pail against 66 from a bottle. A 20 L tank divides that differently again, which is why pack size is a decision about how long an open pail sits in the cupboard.
| Check | What you should see | Why it matters |
|---|---|---|
| Dilution | 1:400 to 1:600 on the label | A bath mixed too rich foams and cushions cavitation |
| Lot and expiry | Printed on the pail, legible | Traceable if a load later looks under-cleaned |
| Pack size | Matches the tank, not the shelf | An open pail outlives its usefulness in a small clinic |
| Seal and cap | Intact, no weeping, no residue | A leaking pail arrives partly empty |
What should make you reject a pail outright?
A broken seal, a missing lot number, an expiry inside the current quarter, or a ratio that does not match what the bath was set up for. Rejecting at the door costs a phone call. Accepting and finding the mismatch at the bench costs a drained tank, a refill and a load run again.

Where does the lot number go once the pail is open?
Onto the bath log, next to the fill date, the dilution used and the cycle temperature. When a load is questioned, the question travels backwards through the bath log to the pail, and a pail with no lot in that log ends the trail.
How is a fresh bath brought into use?
Fill, dose, and run the bath before it sees an instrument. A fresh fill holds dissolved air, and the first cycle after a refill spends part of its energy on that air: the cycle after a change is a degassing run. Warm the bath into the 20 to 50 C band the concentrate is formulated for.
Running a dental practice? The dental practice supply line lists the tanks, concentrates and packaging that share a bench.
Not sure how this applies to your own setup? Ask a sterilization compliance specialist and you get a written answer for your equipment and province, with the regulation or standard cited.
Ordering for a clinic, a lab or a care home? Wholesale and multi-site ordering covers case pricing and account setup, and the B2B wholesale collection lists the lines stocked for institutional buyers. Reselling? become a distributor.
References
- Public Health Ontario - PIDAC-IPC guidance on cleaning, disinfection and sterilization in health care settings (3rd edition, 2013) (checked 19 November 2026)
- Health Canada - Guidance documents for medical devices, including reprocessing information for reusable devices (checked 19 November 2026)
Printable companion: the bath change and receiving log sheet carries the lot, date and dilution fields that turn a delivery into a record.
Reordering pails a quarter and guessing the next one? The clinic supply planner turns bath changes per week into pails per year.
Related Reading
- Ultrasonic Cleaner Solution Canada: Dilution Ratios and Case Sizes
- How Often Should a Dental Office Change Ultrasonic Cleaning Solution?
- Ultrasonic Cleaner for Dental Clinics: Tank Size, Degassing and Cycle Verification
Frequently Asked Questions
What should I check first when the pail arrives?
The dilution ratio on the label, the lot number and expiry, and the seal on the pail. Those three decide whether the delivery matches the order and whether the batch can be traced.
How do I confirm the dilution suits my tank?
Divide the working solution the pail makes by your tank volume. A 5 L pail at 1:400 makes about 2,000 litres, roughly 333 fills of a 6 L tank; a 1 L bottle makes about 400 litres.
Does the concentrate change colour or smell over time?
Follow the shelf life the manufacturer prints rather than appearance. Enzyme activity is not something a visual check confirms, and a pail stored through a freeze or a hot summer is suspect on the date.
Should the bath be changed on a fixed interval?
PIDAC-IPC guidance states the solution should be changed at least daily, and more often if visibly soiled or the manufacturer specifies otherwise. Fresh chemistry in a soiled bath still stops cleaning.
Last updated: November 2026. CliniEco Medical is a licensed medical device establishment (MDEL #35334).