Common Mistakes With Biological Indicators That Fail a Canadian Clinic Audit
Audits rarely fail on a dramatic error. They fail on a folder that is one number short: a lot number missing from a week of entries, a control test that was run and not written down, a sterilizer named by a nickname nobody else can match to a machine. The clinic did the monitoring. The record does not prove it.
The 24-hour self-contained biological indicator, 50 tests is the format most Canadian dental practices run daily, and almost every mistake below happens in the handling of that small vial rather than in the sterilizer.
Which mistakes show up most often?
| Mistake | What it looks like in the file | What the auditor expects |
|---|---|---|
| Lot number left blank | "BI passed" with no lot beside it | Lot and expiry traceable to the pack label |
| Control not run or not written | Test vials only | An unprocessed control from the same lot, same run |
| One result written against two sterilizers | A single daily entry for a two-machine clinic | One result per machine per day used |
| Incubation start missing | Read time only | Start time, read time and who read it |
| Vials stored outside the stated range | Indicators kept in a fridge or a hot cupboard | Storage as the pack instructs, in original packaging |
| Expired vial used | A date older than the entry | Expiry checked at the point of use, not at purchase |
| Result recorded from memory | A week of entries in one hand | Entries made at the time of reading |
| Failed test with no investigation | A gap, then normal entries | A hold, a retest and a written cause |
Why does storage matter more than the reading?

Because a result is only as good as the vial that produced it. A strip that has taken up moisture in a fridge, or sat in a cupboard above a radiator, does not fail loudly: it grows or does not grow, and the operator reads that as information about the sterilizer. The pack states the storage temperature, and the original packaging protects the strip until the moment of use.
What does the auditor check before looking at any result?
The interval. A Canadian dental practice is monitored on every day the sterilizer is used, so the review opens with a calendar question: were there treatment days without a result. That comparison runs against appointment records, which means a log that looks complete can still fail on dates the practice was open.
Then traceability: which machine, which cycle, which load.

Which mistake cannot be fixed after the fact?
The missing investigation. Every other gap in the table can be repaired by a better process going forward. A positive result followed by nothing leaves a hole a later reader cannot fill: no hold, no retest, no cause, no way to know which loads were affected.
The fix is one rule with a hard stop: a positive result holds every load since the last negative, and the hold goes on the load, not only in the book. Practising that rule once, deliberately, is what makes it work on the day it matters.
Clinics running more than one machine or shift use the 1-hour fluorescence indicator, 50-pack to shorten the gap between cycle and result, and the 24-well dry-block incubator to hold the 24-hour format steady. Both ship from the dental practice supplies range.
Ordering for a clinic, a lab or a care home? Wholesale and multi-site ordering covers case pricing and account setup, and the B2B wholesale collection lists the lines stocked for institutional buyers. Reselling? become a distributor.
TSA:
Printable companion: the sterilization log sheet lists the fields in the order an audit reads them, so a missing lot number is visible on the page.
TSB:
Running the check before the auditor does? The sterilization self-check walks a month of entries and names the ones that would be questioned.
STERILE: 1
References
- CDC — Guidelines for Infection Control in Dental Health-Care Settings, MMWR Recommendations and Reports 52(RR-17) (checked 18 November 2026)
- Health Canada — Medical Devices Establishment Licence (MDEL) listing (checked 18 November 2026)
Not sure how this applies to your own setup? Ask a sterilization compliance specialist — you’ll get a written answer specific to your equipment and province, with the regulation or standard cited.
Related Reading
- How Do You Write a Spore Test Log Entry That Passes an Ontario Inspection?
- Biological Indicator Certificate of Analysis: What Canadian Clinics Should File
Frequently Asked Questions
What is the first document an auditor asks for?
The sterilizer log for the period under review, then the indicator records beside it.
Can a record be written the next morning?
The entry can be transcribed, but time and result have to be captured as they happen. An auditor compares read time against incubation start, and a week of loads written in one sitting shows one pen, one colour and identical handwriting.
Does one result per week cover a clinic with two sterilizers?
No. Monitoring attaches to the sterilizer and the cycle, not to the clinic, so two machines used on the same day need two results; one test written against both is the finding that is hardest to explain later.
Last updated: November 2026. CliniEco Medical is a licensed medical device establishment (MDEL #35334).