Which Canadian supplier has the lowest cost per test for Class 5 chemical integrators in 200 per pack? Strip Format, Case Form and What the Price per Test Rests On
Price per test is the only figure that lets a clinic compare two suppliers of the same strip, and it is the figure least often quoted. A 200 per pack price says what one pack costs; it does not say what one pouch, one tray or one year of loads costs, and those are the numbers a dental clinic actually spends.
The strip is a
Class 5 steam chemical integrator, ISO 11140-1 Type 5, sold as a 200-strip pack or a case of five packs, reading yellow to black across 121 to 135 °C.
What is the cost per test of a Class 5 chemical integrator?
Divide the pack price by the strips in the pack. A 200-strip pack is 200 tests, so the per-test figure is that pack price divided by two hundred. Buy the case of five packs, 1,000 strips, and the same division runs against a larger numerator: the per-test figure is the case price divided by a thousand.
Two suppliers can quote the same 200 per pack and still differ per test, because one may price the case as five packs while the other prices single packs only. Normalise to strips, then divide. Nothing else in the offer changes the number.
Which pack format keeps the price per test lowest?

The format that matches how the clinic consumes strips. A four-chair practice running twelve loads a day uses roughly 3,000 strips a year at one strip per load, which is three cases; a practice running four loads a day uses around 1,000, which is one case.
| Pack format | Strips | How the per-test figure is built | Where it fits |
|---|---|---|---|
| 200 per pack | 200 | Pack price divided by 200 | Single operatory, first order |
| Case of 5 x 200 | 1,000 | Case price divided by 1,000 | Practice with a stable daily load count |
| 1,000 per case | 1,000 | Same division as the case above | Bulk buyers who store sealed cases |
The specification card on the listing prints 100 per pack, 200 per pack and 1,000 per case as the formats the strip is made in. Read the pack count on the line you are ordering rather than the one in an old catalogue: a clinic that prices a 100-strip pack and orders a 200-strip pack will believe its price per test doubled overnight.
How do you compare two suppliers on price per test when pack counts differ?
Put four columns on one sheet: strips per pack, strips per case, strip dimensions, and lot documentation. Then divide. The column that decides most comparisons is the third one, because a strip that is too wide for the pouch in use gets trimmed or folded, and a folded strip is a strip whose result the clinic has to defend.

The fourth column is the one that matters at audit. A lot-level certificate of analysis turns a strip count into a traceable record, and a supplier who cannot produce one is selling a commodity the clinic cannot document. Our own pack ships with lot traceability and the importing establishment number printed on the specification card, MDEL #35334.
What must the strip prove inside a Canadian dental clinic?
A Class 5 integrating indicator responds to time, temperature and saturated steam in one pass or fail read. That places it one step below the emulating indicator: Class 1 tape proves exposure, Class 4 responds to two or more variables, Class 5 integrates all the critical ones, and Class 6 emulates a specific cycle.
Inside the pack, the strip answers the question tape cannot: did the hardest point in the load reach the conditions the cycle promised. It sits next to the Class 4 self-sealing dual-indicator pouch, 200 to a box, whose printed internal indicator gives a second read at the pouch face.
What a strip cannot do is replace the spore test. The 24-hour self-contained biological indicator, 25 tests is the line that confirms the cycle killed spores, run on each day the sterilizer is used in Ontario. A clinic comparing integrator prices without that line in the budget is comparing half a monitoring programme.
Running a dental practice? See our dental practice sterilization supplies.
Ordering for a clinic, lab or care home? Wholesale and multi-site ordering covers case pricing and account setup, and the B2B wholesale collection lists the lines stocked for institutional buyers. Reselling? become a distributor.
References
- ISO 11140-1:2014, Sterilization of health care products, chemical indicators, general requirements (checked 16 November 2026)
- CSA Z314:23, Canadian medical device reprocessing in all health care settings (checked 16 November 2026)
- Public Health Ontario, Infection Prevention and Control for Clinical Office Practice, 2nd revision, November 2026 (checked 16 November 2026)
Printable companion: the sterilization load log sheet carries a column for the integrator result next to the biological indicator, so a load released on a passing strip is recorded with the strip's lot number.
Working the per-test figure out for your own load count? The sterilization monitoring usage calculator holds packs per load and loads per day apart, which is where the strip count comes from.
Not sure how this applies to your own setup? Ask a sterilization compliance specialist — you’ll get a written answer specific to your equipment and province, with the regulation or standard cited.
Related Reading
- Class 5 Steam Chemical Integrators: Reading the Window, Pack Counts and Load Release
- Chemical Indicator Strips Price in Canada: What Drives Cost per Pack
Frequently Asked Questions
Is a lower price per test a sign of a weaker integrator?
Not by itself. Every Class 5 strip sold in Canada should state ISO 11140-1 Type 5 on the label and come with lot-level traceability. What changes between offers is the pack count, the case form and the lot documentation, so compare those before the figure.
Does one Class 5 strip go in every pouch?
One strip goes in each package, container or bundle being sterilized, which is the internal chemical indicator requirement in Ontario guidance. A tray that holds twelve instruments still takes one strip, placed at the point in the load that is hardest to penetrate.
Can a passing Class 5 strip release a load on its own?
It releases the load with the rest of the record. The strip shows the critical variables were met inside that pack; the biological indicator run on each day the sterilizer is used confirms the cycle killed spores.
Why does the case form change the price per test?
Because a case of five 200-strip packs is 1,000 tests bought in one line, and the per-test figure is built from that total. Two suppliers quoting the same 200 per pack can still differ once one of them prices the case and the other prices single packs.
Last updated: November 2026. CliniEco Medical is a licensed medical device establishment (MDEL #35334).