Where to Order Contact Lens Solution in Canada: Bottle Sizes, Case Counts and Rotation

Pair of blue nitrile examination gloves photographed on a white background

Quick facts

  • A soft contact lens care product is a Class II device in the United States under 21 CFR 886.5928, with special controls and a named guidance document.
  • ISO 14534:2011 sets fundamental requirements for contact lenses and contact lens care products as a pair, not for the lens alone.
  • Saline and rewetting drops are not disinfectants; the American Academy of Ophthalmology states this directly in its lens-care guidance.
  • A lens case should be replaced at least every three months, or immediately if it is cracked or damaged.
  • Lenses stored for 30 days or longer without re-disinfecting should not be worn until they are re-disinfected.
  • Opened bottles are dated on opening, not on delivery; the discard date is counted from the first use.

Ordering contact lens solution for a clinic is a rotation problem disguised as a purchasing problem: the bottle with the lowest cost per millilitre is the one most likely to sit opened past its discard date in a drawer. This article works through the three numbers a Canadian clinic actually needs before placing an order — how much solution one patient uses in a year, which bottle format matches that use, and how the opened-bottle date and the case replacement date interact — then sets the Canadian and US rule picture side by side. The multipurpose solution referenced throughout is stocked as multipurpose contact lens solution, and the gloves used whenever a lens is handled in the chair are nitrile examination gloves, 3.5 mil, 1,000 per case.

What counts as one patient-year of solution?

The arithmetic starts with the wear schedule, not with the bottle. A daily-wear patient who cleans and disinfects once a day uses roughly 3 mL to 4 mL per session for a rub-and-rinse regimen, plus the volume used to rinse the case. At 3.5 mL a day the patient-year is about 1.28 litres; at 4 mL it is about 1.46 litres. A patient who disinfects every second day and rinses with saline in between sits near half that figure, which is why a clinic cannot size an order from the number of patients alone.

Wear and care pattern Solution per session Sessions per year Solution per patient-year Bottle format that fits
Daily wear, rub and rinse, daily disinfection 3.5 mL 365 ≈1.28 L Two 360 mL bottles plus one 120 mL travel bottle
Daily wear, no-rub multipurpose, daily disinfection 3.0 mL 365 ≈1.10 L Three 360 mL bottles
Extended wear, weekly disinfection cycle 3.5 mL 52 ≈0.18 L One 120 mL bottle, dated on opening
Part-time wear, three days a week 3.5 mL 156 ≈0.55 L One 360 mL bottle

Two cautions on that table. The per-session figure is a planning number, not a manufacturer instruction: the volume that matters is the one the solution's own directions specify, and the directions on the bottle in your hand override any planning figure here. And the case rinse volume counts, because a case rinsed with tap water is a contamination route the solution cannot undo.

Which bottle size should a clinic stock?

Pair of blue nitrile examination gloves photographed on a white background

Three formats cover almost every clinic need. A 360 mL bottle is the workhorse for a daily-wear patient and the format that gives the lowest cost per millilitre. A 120 mL bottle is the travel and trial size, and it is the right format for a patient starting a new solution because the discard date arrives before the bottle is empty if the patient does not take to it. A 60 mL bottle is a sample format and should be treated as a one-patient, short-window item rather than as stock.

The clinic's own stock should be held in the format that matches its chair-side use, which is usually a 360 mL bottle for lens handling at the slit lamp plus a small number of 120 mL bottles for patients who arrive without their own. Holding a large inventory of 60 mL bottles is the classic over-order: they expire quietly and they encourage staff to hand out a size the patient will not finish.

How do the Canadian and US positions differ?

In the United States a soft contact lens care product is a Class II device with special controls, and the section names the premarket guidance document that applies to it (21 CFR 886.5928). The classification covers cleaning, rinsing, disinfecting, lubricating, rewetting and storing products, and it also covers heat disinfecting units, which is why a clinic that lends a heat unit is lending a device rather than an accessory.

Internationally the product is measured as one half of a pair. ISO 14534:2011 sets fundamental requirements for contact lenses and contact lens care products together (ISO 14534:2011), which is the reason a clinic's lens brand and solution brand are not independent choices: a solution is evaluated against the lens materials it is intended to care for.

Point of comparison Canada United States
How the product is regulated As a medical device under the federal device regulations, with the class set by the classification rules applied to intended use 21 CFR 886.5928, Class II with special controls
Premarket expectation Device licence held by the manufacturer for Class II and above; importer or distributor holds an establishment licence (MDEL) 510(k) with the named care-product guidance
Product standard ISO 14534:2011 read alongside the lens standard Recognised consensus standards plus the care-product guidance
Who answers the clinical question Provincial college and the prescribing optometrist State scope-of-practice rules and the prescriber
Labelling language English and French for products sold in Canada English only at federal level; state rules may add requirements

The labelling row is the one that changes an order. A clinic that buys a US-only carton has bought a product whose labelling was not prepared for the Canadian market, and the bilingual requirement is a packaging fact rather than a clinical one.

What does a shelf-life and rotation policy look like?

Six rolls of white cotton roll photographed on a white background

Two dates govern every bottle: the expiry printed by the maker and the discard date counted from opening. The maker's expiry assumes an unopened bottle; the discard date assumes the bottle has been open and the tip has been in contact with air and possibly with a lens case. A workable policy writes the opening date on the bottle in marker at the moment the seal is broken, and it writes the discard date next to it, because a date that has to be calculated at the point of use is a date that gets skipped.

The American Academy of Ophthalmology's lens-care guidance supplies the patient-facing rules that sit behind that policy: use new solution each time, never reuse old solution and never add fresh solution to what is left in the case, keep the bottle tip from touching any surface, and keep the bottle tightly closed when it is not in use (AAO contact lens care). The same page states that saline and rewetting drops are not disinfectants, which is the single most useful sentence to have on a clinic handout.

Cases are part of the rotation, not an accessory. The Academy's guidance is to replace the case at least every three months, or immediately if it is cracked or damaged, and to rinse it with sterile contact lens solution rather than tap water and let it air dry open. A clinic that hands out solution without a case replacement schedule has solved half the problem.

What should the order form and the receiving check say?

A clinic order form for solution should carry the product name and manufacturer, the bottle volume, the units per case, the lot number on receipt, the expiry date on receipt, the storage temperature range from the carton, and the bilingual labelling confirmation. The receiving check is three lines: carton intact, expiry at least the interval your policy requires, and lot recorded against the delivery date.

Storage is the quiet failure. A carton left on a loading dock in July or against an exterior wall in January has been outside the range the maker specifies, and the expiry date does not cover that. The carton's own storage statement is the authority; a stockroom that keeps solution next to a radiator is not complying with it.

Where a clinic also dispenses lenses and cases, the same rotation logic applies to the lens case stock and to the eye patch and occluder range used in the same chair.

Which questions does a supplier audit ask?

Four questions separate a supplier that understands the product from one that is moving cartons. First, can they state the device class and the standard the product is built to, in writing? Second, can they supply the lot and expiry at the case level rather than on request after delivery? Third, do they hold an establishment licence for importing, and will they put the number on the invoice? Fourth, do they understand the difference between the maker's expiry and the opened-bottle discard date, which decides whether a short-dated carton is a bargain or a write-off?

A supplier who answers all four in writing is a supplier whose invoice can be filed next to the product record without a follow-up email. That is the practical test, and it costs ten minutes before the first order rather than an afternoon after the first inspection.

Solution is a rotation item, so the order size should follow the discard date rather than the case discount. Order through the wholesale programme for case pricing and an account, or become a distributor for resale. The multipurpose solution bottle sits in the same catalogue. Clinics that hold both solution and lens-handling consumables on one account tend to write the rotation policy once and apply it to both. Consumables for this line are listed under the department page.

Sources

  1. 21 CFR 886.5928 — Soft (hydrophilic) contact lens care product, Class II
  2. ISO 14534:2011 — Ophthalmic optics, contact lenses and contact lens care products
  3. American Academy of Ophthalmology — contact lens care
  4. American Academy of Ophthalmology — infection control in the eye clinic
  5. American Academy of Ophthalmology — blepharitis and warm-compress care
  6. Canadian Association of Optometrists
  7. Public Health Ontario — infection prevention and control topic index
  8. Provincial guidance for cleaning, disinfection and sterilization in health care settings (PHO)
  9. CCOHS — OSH Answers index (chemical and workplace safety reference)
  10. ISO 10939:2017 — slit-lamp microscopes, used for the chair-side lens check
  11. 21 CFR 886.1850 — AC-powered slitlamp biomicroscope
  12. CliniEco — contact lens solution and case stock: cost per patient-year
  13. CliniEco — multipurpose solutions: which care system applies
  14. CliniEco — hydrogen peroxide solutions: which rules apply
  15. CliniEco — eye clinic consumables for optometry
  16. CliniEco — diagnostic laboratory department page
  17. CliniEco — printable compliance log centre

The rotation policy only works if somebody can see it: the printable log sheets at the compliance log centre include an opened-bottle date column you can stick on the stockroom shelf.

For clinics that would rather generate the sheet than download it, the log generator on the same page produces a dated rotation sheet sized to the shelf labels you already use.

Ask a compliance specialist at the consultation desk with your province and the solution format you stock, and the answer comes back in writing with the labelling and device rule it is based on cited — no account and no sign-up.

Related reading

CliniEco Medical is a Canadian medical device importer with MDEL #35334. Nothing in this article is clinical advice for a specific patient, and no product in it is presented as a substitute for the instructions supplied with a device.

Frequently Asked Questions

Is contact lens solution a device or a drug in Canada?

It is regulated as a medical device, and in the United States it sits in 21 CFR 886.5928 as a Class II device with special controls. The practical consequence for a clinic is that the establishment importing it needs an establishment licence, and the labelling has to meet the Canadian bilingual requirement.

How much solution does one daily-wear patient use in a year?

At a planning figure of 3.5 mL per session and one session a day, about 1.28 litres; at 4 mL, about 1.46 litres. Those are planning numbers for order sizing only. The volume that should actually be used is the one the solution's own directions specify.

Can a clinic hand out saline instead of a disinfecting solution?

No. The American Academy of Ophthalmology states plainly that saline and rewetting drops are not disinfectants. Handing a patient saline in place of a care system leaves the lens undisinfected, which is the failure mode that matters clinically.

When should the lens case be replaced?

At least every three months, and immediately if it is cracked or damaged. Cases should be rinsed with sterile contact lens solution rather than tap water and left open to air dry.

Does the expiry date on the carton cover an opened bottle?

No. The maker's expiry assumes an unopened bottle. Once the seal is broken the discard date is counted from opening, which is why the opening date should be written on the bottle at the moment of first use.

A patient left lenses in the case for two months. Can they wear them?

Not until the lenses have been cleaned and disinfected again. Academy guidance is that lenses stored for 30 days or longer without re-disinfecting should be re-disinfected before wear, and the instructions supplied with the lens and the solution should be read before that is done.

Vous travaillez déjà avec des cliniques ? Devenez représentant régional.