Quick facts
- Canada has no national design standard for eyewash stations. CCOHS states that ANSI/ISEA Z358.1-2014 (R2020) is generally used as the guide, and that provincial legislation still governs whether a unit is required.
- The same CCOHS guidance gives the design numbers: a person should reach the unit within 10 seconds, the unit must supply flushing fluid for at least 15 minutes, and the water should be tepid, defined by ANSI as 16-38 °C.
- ANSI recommends weekly activation and a signed, dated record kept by a named person.
- Ontario Regulation 851, s.124 requires eye wash facilities where a worker may be exposed to a hazardous biological or chemical agent, and requires the equipment to be marked, conspicuous, readily accessible and labelled with instructions.
- British Columbia goes further on testing: OHS Regulation s.5.93(2) requires a plumbed unit to be full-flow tested at least once per month, and s.5.93 defines tempered water as 15-30 °C.
- Facts and page text were read on 2026-10-19; the Ontario and BC provisions were read from the current consolidated regulations the same day.
An eyewash station is the one piece of clinic equipment that is judged after something has already gone wrong, which is why the maintenance record matters as much as the plumbing. Canada has no national design standard for the unit itself, so most facilities borrow ANSI/ISEA Z358.1 for placement and flow, while the legal duty to provide, mark and test the unit comes from provincial occupational health law. This article sets out the weekly, monthly and annual tasks, the temperature and flow numbers an inspector will ask for, and the fields a log needs; the wall-mount unit we stock is the CliniEco eye wash station, and the record is what makes it defensible.
When does a Canadian clinic need an eyewash station?
The trigger is exposure risk, not the presence of a chemical cupboard. Ontario Regulation 851 s.124(1) says that where a worker is required to work with, or is likely to be exposed to, a hazardous biological or chemical agent that could cause injury to the eye or skin, the employer must provide as many of eye wash facilities, emergency showers and antidotes or flushing fluids as are needed for adequate emergency treatment.
Subsection (2) adds four conditions that inspectors check first: the equipment must be clearly marked with a sign or label; located or installed in a conspicuous place near where the agent is kept or used; readily accessible to workers; and have instructions for use displayed on or near it.
In practice the risk assessment decides. A dental office with acid etch, a laboratory with formalin or strong alkali, a food plant with caustic cleaning agents and a medical clinic with glutaraldehyde-based disinfectant are all candidates. The assessment should name the agent, the task, the volume and the distance to the nearest unit, because those four facts are what the placement rule is measured against.
How often should a plumbed eyewash station be activated?
Two obligations run in parallel and neither replaces the other. ANSI/ISEA Z358.1, as summarised by CCOHS, recommends weekly activation of every plumbed shower, eyewash, combination unit and drench hose, with one named person responsible and a signed, dated record. The purpose is not only to prove the valve works; running the line clears sediment and reduces the microbial load that builds in standing water.
Provincial law sets its own floor. BC OHS Regulation s.5.93(2) requires a plumbed emergency eyewash or shower facility to be full-flow tested at least once per month, for long enough to completely flush the branch of the water line supplying the eyewash. A clinic in British Columbia that activates weekly is doing more than the legal minimum, which is the sensible position: weekly activation satisfies the monthly test as long as the record shows a full-flow flush and not a two-second handle wiggle.
Ontario Regulation 851 does not set a testing interval in s.124. That silence is not permission to skip testing. The employer still has to keep the equipment in a state that provides adequate emergency treatment, and a written maintenance schedule is the ordinary way to evidence that. A clinic with no interval and no log has no answer when an inspector asks how it knows the unit works.
| Task | Frequency | Source | What the record shows |
|---|---|---|---|
| Activate the valve and run the unit | Weekly | ANSI Z358.1 recommendation via CCOHS | Date, time, initials, duration |
| Full-flow flush of the supply branch | At least monthly | BC OHSR s.5.93(2) for BC workplaces | Date, duration, flow observed |
| Inspect sign, access path and nozzle covers | Weekly | Ontario Reg 851 s.124(2); ANSI | Pass or defect, action taken |
| Check water temperature at the outlet | Weekly or monthly | ANSI tepid range; BC tempered definition | Measured °C |
| Annual inspection of the whole unit | Annual | ANSI Z358.1 recommendation | Inspector, findings, parts replaced |
| Replace self-contained fluid or bladder | Per manufacturer expiry | Manufacturer instructions | Lot, expiry, replacement date |
What temperature and flow must the water meet?
ANSI defines tepid water as 16-38 °C. CCOHS explains why the upper limit matters: water above 38 °C is harmful to the eyes and can enhance the chemical interaction with skin and eyes, while long flushing with water below 16 °C can cause hypothermia and shorten the flush before it has done its work. In a Canadian building the risk is almost always the cold end, where indoor plumbing can sit at 2-7 °C in winter.
British Columbia uses a narrower definition. The OHS Regulation defines tempered as maintained at 15-30 °C. That is a real operational difference: a unit set to run at 35 °C would satisfy the ANSI band and fail the BC definition. A clinic with sites in more than one province should therefore set the mixing valve to the intersection of the two ranges, roughly 16-30 °C, and record the measured temperature rather than the set point.
Flow is the other number. ANSI's eyewash flow is about 1.5 litres per minute, and BC's definition of a continuous flow eyewash facility uses the same minimum of 1.5 litres per minute with pressure not exceeding 175 kPa (25 psi). A flow that looks generous at the nozzle can still be starved by a partly closed isolation valve, which is why the monthly test is described as a full-flow test and not a pressure check.
| Parameter | ANSI/ISEA Z358.1 (R2020) | British Columbia OHSR | Practical setting |
|---|---|---|---|
| Water temperature | Tepid, 16-38 °C | Tempered, 15-30 °C | 16-30 °C covers both |
| Flush duration supplied | At least 15 minutes | 15 minutes minimum for portable units at transient sites | Verify by timed run |
| Eyewash flow | About 1.5 L/min | Minimum 1.5 L/min, pressure ≤175 kPa | Measure at the nozzle |
| Travel distance | Reachable in 10 seconds, about 16-17 m | Accessible and unobstructed | Walk the route |
| Activation | Less than 1 second, stays on without a hand | Not specified in s.5.93 | Test the stay-open valve |
What belongs in the maintenance log?
A log with a tick box proves very little. The useful record identifies the unit, the person, the measurement and the defect. At minimum: unit location and asset number, date and time, whether the valve was activated and for how long, the measured water temperature, whether the flow was full and unobstructed, the condition of the sign and nozzle covers, any defect found, the work order raised, and the initials of the person who did the work.
CCOHS is explicit that the named person should keep a signed, dated record, and that ANSI also recommends a complete annual inspection. The annual entry should be different in kind from the weekly one: it is the point at which hoses, strainers, valves, the mixing valve and the mounting are examined, not merely operated. If the unit has a self-contained bladder, the annual check also confirms the replacement date against the manufacturer's expiry.
The log is also the defence when a unit is out of service. A station that is tagged out, with the date, the reason and the alternative route to the next unit written down, is a controlled condition. A station that is simply broken is an uncontrolled one, and the absence of any entry is what turns a maintenance problem into a finding.
What is different about self-contained and personal units?
A plumbed unit has an effectively unlimited supply as long as the line is open. A portable, self-contained unit has a measured volume and a shelf life, and both are easy to lose track of. CCOHS notes that maintenance is critical because the unit must be fully charged at all times, that the bladder must be replaced after activation, and that the fluid has an expiry date to check.
The 15-minute rule still applies to the supply the unit can deliver. A portable unit that holds four minutes of fluid is a supplement, not a substitute, unless the risk assessment says a plumbed station is within the ten-second reach and the portable unit only bridges the walk. BC's regulation makes the same distinction: a personal eyewash unit supplements an emergency eyewash facility by delivering immediate flushing for less than 15 minutes.
Personal wash bottles are for the first seconds of a splash, while the person is being moved to a plumbed unit. They are not a station. The record for a bottle is simpler - fill date, expiry, location - but it still exists, and a bottle with no date is indistinguishable from one filled last week or last year.
What fails an inspection most often?
The plumbing is rarely the problem. The common failures are organisational: a unit blocked by a cart or a bin, a sign missing or faded, nozzle covers that need two hands to remove, a mixing valve that delivers water at 8 °C in February, and a log with ticks but no temperatures. Each of these is cheap to fix and expensive to explain.
The second group is documentary. A clinic can show a policy but not a record; a record but not a named responsible person; a weekly tick but no monthly full-flow entry where the province requires one. The fix is a single sheet per unit per year, with the weekly rows, the monthly full-flow rows and the annual inspection row already printed, so that a missing week is visible as a gap rather than hidden in a binder.
The third group is behavioural. Staff do not know where the unit is, or hesitate to set it off because they fear the clean-up. That is a training problem, and BC s.5.94 makes the training duty explicit for workers required to use the facilities. A two-minute drill at orientation, with the valve actually opened, is worth more than a laminated poster.
Emergency equipment is only half of the eye-safety routine; the other half is what the clinic stocks beside it. Order through the wholesale programme for case pricing and an account, or become a distributor for resale. The wall-mount eye wash station sits in the same catalogue.
Sources
- CCOHS, Emergency showers and eyewash stations
- Ontario Regulation 851, Industrial Establishments, s.124
- British Columbia OHS Regulation, Part 5, ss.5.85-5.95
- OSHA 29 CFR 1910.151(c), medical services and first aid
- ANSI/ISEA Z358.1-2014 (R2020), emergency eyewash and shower equipment (referenced via CCOHS)
- Public Health Ontario, infection prevention and control
- Health Canada, medical devices
- Health Canada, establishment licensing
- Medical Devices Regulations, SOR/98-282
- ISO 13485:2016, medical devices quality management
- ISO 14971:2019, application of risk management to medical devices
- ISO 17664-1:2021, processing of health care products
- Canadian Centre for Occupational Health and Safety, OSH answers
- CSA Group, standards catalogue
- Standards Council of Canada
- Canadian Association of Optometrists
- Canadian Ophthalmological Society
- Royal College of Dental Surgeons of Ontario, standards and guidelines
Printable eyewash and emergency-equipment log. A weekly valve check is only evidence if the date, the temperature and the initials are on one sheet. Print an emergency equipment log - one page per unit per year, with weekly rows, a monthly full-flow row and an annual inspection row already laid out; it prints on plain paper with no account and no sign-up.
Dated log generator. Choose the unit, the room and the test interval and the page builds a twelve-month sheet with the temperature column and a defect-and-action column. Build an eyewash test calendar so that a missed week shows as a gap rather than disappearing into a binder.
Ask a compliance specialist. Whether a station is required, how far it may be from the task and which provincial interval applies are questions that turn on your agents and your province. Ask a compliance specialist - written answer specific to your equipment and province, with the regulation or standard it is based on cited.
Related reading
- Eye wash stations in Canada and the US: which standard applies at the bench
- Eye wash solution in Canada and the US: which flushing fluid rules apply
- Ophthalmic eye shields in Canada and the US: which device rules apply
CliniEco Medical supplies eye care, laboratory and dental consumables of the kind described in this article. MDEL #35334. This article is written for clinic and laboratory managers and is not legal advice; the equipment a workplace must provide, and the interval at which it is tested, are set by the legislation that applies to that workplace.
Frequently Asked Questions
Is there a Canadian standard for eyewash stations?
No national design standard exists. CCOHS states that ANSI/ISEA Z358.1-2014 (R2020) is generally used as the guide for design and placement, while provincial occupational health legislation decides whether a unit is required and how it must be maintained.
How often should an eyewash station be flushed?
ANSI recommends weekly activation with a signed, dated record. British Columbia requires a plumbed unit to be full-flow tested at least once per month under OHS Regulation s.5.93(2). A weekly flush satisfies the monthly test when the record shows a full-flow run.
What temperature should the water be?
ANSI defines tepid as 16-38 °C. British Columbia defines tempered as 15-30 °C. Setting the mixing valve to roughly 16-30 °C satisfies both, and the measured temperature belongs in the log.
Does Ontario require a specific testing interval?
Ontario Regulation 851 s.124 requires eye wash facilities where exposure is possible and sets marking, location, access and instruction conditions. It does not state a testing interval, so the employer's written maintenance schedule is what evidences that the unit is kept fit for emergency use.
How long must a unit be able to flush?
At least 15 minutes of flushing fluid. ANSI does not specify how long a casualty should rinse; it specifies that the equipment can supply fluid for at least 15 minutes, and the safety data sheet for the agent guides the actual rinse.
What is the difference between a personal wash bottle and a station?
A personal unit delivers immediate flushing for less than 15 minutes and supplements a station. It does not replace one. BC's regulation defines it that way, and a portable unit still needs a fill date, an expiry date and a location in the record.