Quick facts
- The American Academy of Ophthalmology contact lens care guidance is direct: "Do not use saline solution or rewetting drops to disinfect your lenses. They are not disinfectants."
- The same page tells patients never to use a homemade saline solution and never to rinse or store lenses in tap water or sterile water, because water is the route by which organisms reach the lens case.
- Saline has a legitimate job - rinsing, and in some systems storing a lens in a preservative-free environment for a short period - but a lens that is only rinsed and returned to its case has not been disinfected.
- Contact lens care products are regulated as devices: in the United States the rigid gas permeable care products sit at 21 CFR 886.5918, Class II, and in Canada the same products are licensed under the Medical Devices Regulations.
- ISO 14534 sets fundamental requirements for contact lenses and for the solutions sold to care for them, which is why a clinic should not improvise with a laboratory rinse.
- Sources were read on 2026-10-20; the AAO pages and the ISO catalogue entry returned 200, and the classification data came from the openFDA API the same day.
Saline is the product most often mistaken for a care system, because it is sold next to the care systems, it says "for sensitive eyes" on the front and it costs less. The mistake is not harmless: a lens stored in saline overnight has been rinsed, not disinfected, and the case becomes the place where organisms accumulate. This article sets out what saline does, what it does not do, how it differs from multipurpose and peroxide systems, and what a Canadian optometry practice should keep on the shelf so that a patient who runs out of solution is not handed the wrong bottle. The gloves used at the fitting are the CliniEco nitrile examination gloves, and any lens that leaves its case should be handled the way the lens manufacturer's instructions require.
What does saline actually do for a contact lens?
Saline rinses. It lifts debris, it dilutes the residue of a cleaning solution and it provides a liquid medium in which a lens can be transferred from a case to an eye without tap water touching it. In a heat disinfection system, saline is the medium that carries the heat; the disinfection is done by the heat, not by the salt.
What saline does not do is kill. A preservative-free saline has no antimicrobial action at all, and a preserved saline has a preservative intended to protect the solution in the bottle rather than to disinfect a lens that has been on an eye. The AAO guidance states the point without hedging: saline and rewetting drops are not disinfectants.
The consequence is mechanical. A lens that is rinsed and put back in a case in saline sits in a film of whatever the eye deposited on it, and the case holds that film against the lens until the next wear. That is why the same guidance tells patients to rub and rinse with the care solution, to use fresh solution each time, and to replace the case regularly.
How do multipurpose, peroxide and saline systems differ?
A multipurpose solution combines a surfactant cleaner, a disinfectant and a conditioning agent, and it depends on the rub-and-rinse step to work. A hydrogen peroxide system separates the jobs: the peroxide disinfects, and a neutralising disc or tablet converts it to saline over the stated time. A saline is the rinse, and in a heat system it is the medium.
The three fail in different ways. A multipurpose system fails when the patient skips the rub, or reuses old solution, or tops up the case instead of emptying it. A peroxide system fails when the lens is removed before neutralisation has finished, which carries peroxide to the eye and stings. A saline fails because it was never a disinfectant, so there is no step to skip - the protection was never there.
For a practice, the practical difference is what you hand a patient who has run out. Handing a saline bottle to a patient who has been using a multipurpose solution converts a compliant patient into a non-compliant one in a single substitution, and the patient will not know unless someone tells them.
| Product | What it does | What it does not do | Depends on | Typical failure |
|---|---|---|---|---|
| Preservative-free saline | Rinses; carries heat in a heat system | Does not disinfect; no antimicrobial action | A separate disinfection step | Used as storage solution |
| Preserved saline | Rinses; preservative protects the bottle | Does not disinfect a lens that has been worn | A separate disinfection step | Assumed to be a care system |
| Multipurpose solution | Cleans, disinfects and conditions in one bottle | Does not replace case hygiene or the rub step | Rub and rinse, fresh solution, clean case | Rub skipped; old solution reused |
| Hydrogen peroxide system | Disinfects through the peroxide, then neutralises | Does not work if the lens is removed early | Full neutralisation time | Lens worn before the disc finishes |
| Rewetting drops | Lubricates a lens on the eye | Does not disinfect or clean a lens off the eye | Use in the eye, not in the case | Used as a storage solution |
Why is tap water the wrong rinse, and what does the guidance say?
The AAO guidance is unusually specific for a patient page: do not rinse or store lenses in water, tap or sterile; never use a homemade saline solution; never put a lens in the mouth to wet it, because saliva is not sterile. Each of those instructions closes a route by which an organism reaches the lens surface without a disinfectant in the way.
The academy's page on contact-lens-related eye infections repeats the point from the other direction: rinse and store in store-bought solution, because homemade saline can carry organisms. A clinic that mixes its own rinse in a lab, or decants a bulk saline into an unlabelled bottle, is doing at scale what the guidance tells patients not to do at home.
The case matters as much as the bottle. The care guidance tells patients to rinse the case with sterile contact lens solution rather than tap water, to leave it open to air dry, and to replace it regularly or immediately if it is cracked. A clean bottle of saline poured into a biofilm-lined case is a rinse that ends in contamination.
Is contact lens saline regulated the same way in Canada and the United States?
In the United States, contact lens care products are devices, and the rigid gas permeable care products carry a Class II entry at 21 CFR 886.5918. In Canada the same products are licensed under the Medical Devices Regulations, and the licence number on the package identifies the party responsible for the product. Neither regime treats saline as a cosmetic.
The product standard behind the label is ISO 14534, which sets fundamental requirements for contact lenses and for the solutions sold to care for them. That standard is about the product, not about the clinic's workflow, but it explains why a clinic should not substitute a laboratory rinse: the solution has to be compatible with the lens material and with the eye.
What does the United States classification add to the licence Canada requires?
| Item | Canada | United States |
|---|---|---|
| How a lens care product is regulated | Medical device under SOR/98-282; the licence number on the package identifies the licence holder | Medical device under 21 CFR 886.5918 for rigid gas permeable care products, Class II |
| What the label identifies | Licence holder and Canadian label information | Manufacturer and device listing |
| Product standard | ISO 14534 referenced by the manufacturer | ISO 14534 and the FDA guidance for the product family |
| Clinic's own duty | Follow the manufacturer's instructions and the provincial college guidance | Follow the manufacturer's instructions and state practice rules |
The label point is worth teaching to front-desk staff. A saline bottle without a device licence number is not a lower-cost version of a care product; it is a different product, and it may be intended for irrigation rather than for lenses.
What should a practice stock so that patients are not handed the wrong bottle?
Stock the system the practice fits, not the system that is least expensive to keep on the shelf. If the practice fits multipurpose lenses, the shelf needs a multipurpose solution in the size the patient will actually finish before it expires, plus a small traveller size so the patient does not decant into an unlabelled container. If the practice fits a peroxide system, the shelf needs the matching case and neutralising discs, because a peroxide bottle without its case is unusable.
Keep saline for what saline is for: rinsing a lens before disinfection, and as the medium in a heat system where the practice still recommends one. Put it on a different shelf from the care systems, and brief the front desk so that "I need solution" is answered with a question rather than a bottle.
The third item is the case. A care system sold without a replacement case cycle is a system that will be used with a case older than the lens. The AAO guidance ties case replacement to condition as well as to time, which is an argument for stocking cases as a routine line rather than a special order.
How should a practice answer the patient who says saline works fine?
Answer with the mechanism, not with a warning. Saline rinses; disinfection requires an agent that kills, and saline has none. A patient who understands the difference can see why the bottle that feels soothing on the eye is not the bottle that makes a lens safe to put back in the case.
Then ask what the patient actually does at night. Many patients who say they use saline are also using a multipurpose solution for storage and saline for rinsing, which is a legitimate pattern; the problem is the patient who uses only saline. The question separates the two, and it takes ten seconds.
Finally, write the recommendation down. A practice that tells every patient the same thing in the same words, and records the advice in the file, has a defensible position if a patient later presents with a keratitis that began after a substitution.
Emergency flushing and daily lens care are separate lines: the wall-mounted station in the catalogue is built for a chemical splash, not for a lens, and the two should not be presented to a patient as interchangeable. Order through the wholesale programme for case pricing and an account, or become a distributor for resale. The wall-mount eye wash station sits in the same catalogue. Browse the for clinics collection for the lines this article covers.
Sources
- American Academy of Ophthalmology, how to take care of contact lenses
- American Academy of Ophthalmology, contact lens related eye infections
- American Academy of Ophthalmology, how to use eye drops
- openFDA, device classification API (contact lens care products, 2026-10-20)
- 21 CFR 886.5918, contact lens care products
- Health Canada, medical devices
- Medical Devices Regulations, SOR/98-282
- ISO 14534:2011, contact lenses and contact lens care products
- ISO 13485:2016, medical devices quality management
- ISO 14971:2019, application of risk management to medical devices
- ISO 17664-1:2021, processing of health care products
- CDC, Guideline for Disinfection and Sterilization in Healthcare Facilities
- Public Health Ontario, infection prevention and control
- Canadian Association of Optometrists
- Canadian Ophthalmological Society
- Canadian Centre for Occupational Health and Safety, OSH answers
Printable patient handout on the saline question. A single page in plain language: what saline does, what it does not do, and the three questions to ask when the bottle runs out. Print the saline handout - it prints on plain paper with no account and no sign-up, and it is written to be handed over at the fitting rather than read aloud.
Care-system stock builder. Enter the number of new fits per month and the split between multipurpose and peroxide patients, and the page lays out a shelf list with the sizes that match a normal replacement cycle. Build the care-system shelf list so that the traveller size and the replacement case stop being afterthoughts.
Ask a compliance specialist. Whether a saline bottle can be dispensed as a rinse, what the Canadian label has to show and how to record the advice given at a fitting are questions that depend on the product and the province. Ask a compliance specialist - written answer specific to your equipment and province, with the regulation or standard it is based on cited.
Related reading
- Contact lens solution in Canada and the US: which rules apply
- Contact lens rewetting drops in Canada and the US: which rules apply
- Eye wash solution in Canada and the US: which flushing fluid rules apply
CliniEco Medical supplies eye care, laboratory and dental consumables of the kind described in this article. MDEL #35334. This article is written for clinic managers and is not clinical advice; the care system a patient should use is decided by the lens manufacturer's instructions and by the eye care professional who fitted the lens.
Frequently Asked Questions
Can I store contact lenses in saline overnight?
Not as a care routine. Saline rinses but does not disinfect, and the AAO guidance says plainly that saline and rewetting drops are not disinfectants. A lens that is stored in saline has been rinsed, not cleaned and disinfected.
What is the difference between saline and multipurpose solution?
A multipurpose solution contains a cleaner, a disinfectant and a conditioner, and it relies on the rub-and-rinse step. Saline contains no antimicrobial agent intended to disinfect a lens, so it cannot substitute for a care system.
Is homemade saline ever acceptable?
No. The AAO guidance tells patients never to use a homemade saline solution, and its infection page notes that homemade saline can carry organisms. A clinic should apply the same rule to any decanted or mixed rinse.
Why is tap water a problem if the lens looks clean afterwards?
Because water is the route by which organisms reach the lens and the case, and a rinse does not kill them. The guidance tells patients not to rinse or store lenses in tap water, sterile water or saliva.
How often should a contact lens case be replaced?
The AAO care guidance ties replacement to condition as well as to time, and tells patients to replace a case that is cracked or damaged straight away. Stocking cases as a routine line makes the advice easier to follow.
Are saline and rewetting drops regulated products?
Yes. Contact lens care products are medical devices: in the United States the rigid gas permeable care products are Class II under 21 CFR 886.5918, and in Canada they are licensed under the Medical Devices Regulations.