Short answer: Canadian labs buy 100 by 15 mm sterile polystyrene petri dishes by the case. Market case counts commonly run 400 to 500 dishes depending on the sleeve packing; the 100 by 15 mm format we stock ships 320 per case. The vented or non-vented choice follows the incubation method rather than the price. Confirm the growth area quoted by the manufacturer and the vent style before ordering, because both change how a plate performs in an incubator.
The 100 by 15 mm sterile polystyrene petri dish, 320 per case is the size most bench protocols are written around, and it is the format to standardise on before adding a second size.
Vented or non-vented petri dishes: which does a lab need?
Vented dishes allow gas exchange without lifting the lid, which suits incubators where condensation control matters. Non-vented dishes hold moisture more tightly and are used where drying out is the greater risk. Mixing both on one bench is a source of confusion; pick the style your protocol assumes and label the shelf.
How many petri dishes come in a case?
The 100 by 15 mm sterile polystyrene format we stock ships 320 per case. Case counts vary by manufacturer and by whether the dish is vented, so confirm the number on the quote before comparing unit cost.
| Format | Case | Typical use | Check before ordering |
|---|---|---|---|
| 100 by 15 mm, vented | 320 | Incubated culture work | Vent style and lid fit |
| 100 by 15 mm, non-vented | 320 | Work where drying is a risk | Seal and stacking height |
| Smaller diameter | Varies | Screening, teaching | Growth area against protocol |
What should a Canadian lab check before a bulk order?
- Sterility wording. Confirm the dish is described as sterile and that the packaging is intact on arrival.
- Growth area. Ask for the figure the manufacturer quotes, rather than calculating it from the outer diameter.
- Stack height. Confirm how many dishes stack safely in your incubator before you commit to a case size.
- Lot number. Record it on arrival, so a contamination question can be traced to a case.
- Disposal route. Used plates are clinical waste, so confirm the waste stream before opening a case.
What lead time should a lab plan for?
In-stock Canadian cases ship in 3 to 7 business days. A mixed pallet with tubes, tips and plates takes longer because it is assembled before dispatch. Keep four to six weeks of cover if your work is scheduled in batches, since a plate shortage stops a run rather than slowing it.
How should petri dishes be stored?
Store cases in a dry room, off the floor, away from direct sunlight and away from solvents. Polystyrene dishes deform under heat, so a storage room near a loading dock door in summer is a poor choice. Rotate the oldest case forward and check the packaging date on arrival.
How should used dishes be disposed of?
Used plates with cultures are clinical waste and follow the same segregation rules as other laboratory waste: sealed, labelled and routed through the contracted waste stream. Do not put used plates in general refuse, even when the culture is considered non-pathogenic, because the waste contractor's classification is what governs the collection.
Related Reading
For a full ordering checklist, read 100 by 15 mm petri dish ordering checklist. For the vent decision, see vented versus non-vented dishes, and for waste routing read disposing of used plates and cultures.
Ordering for a clinic, lab or care home? Wholesale and multi-site ordering covers case pricing and account setup, and the B2B wholesale collection lists the lines stocked for institutional buyers. Reselling? become a distributor.
Log case counts on the printable lab consumables sheet, and plan batch volumes with the supply planner. Need plates, tubes and tips in one order? Request a bulk quote or ask a compliance specialist.
Related Reading
- 100 by 15 mm petri dish ordering checklist
- Vented versus non-vented dishes
- Disposing of used plates and cultures
- Printable lab consumables sheet
Frequently Asked Questions
How many petri dishes are in a case?
The 100 by 15 mm sterile polystyrene format we stock ships 320 per case. Case counts differ by manufacturer and by vent style, so confirm the number on the quote before comparing unit cost.
Should a lab buy vented or non-vented petri dishes?
Vented dishes allow gas exchange without lifting the lid and suit incubator work where condensation control matters. Non-vented dishes hold moisture and are used where drying out is the larger risk.
How long do sterile petri dishes last in storage?
Sterility is tied to the packaging date and to storage conditions rather than to the plastic itself. Keep cases dry, off the floor and out of heat, and check the packaging date when the case arrives.
Can used petri dishes go in general waste?
No. Used plates with cultures are clinical waste and must be sealed, labelled and routed through the contracted waste stream rather than placed in general refuse.
CliniEco Medical is a licensed medical device establishment (MDEL #35334).