Standard Nitrile Glove Size Chart (ASTM D6319)
Where to Buy Nitrile Examination Gloves in Canada
CliniEco Medical supplies examination-grade nitrile gloves to clinics, laboratories, food facilities and care homes across Canada, shipped from Ontario.
| Option | Recommended for | Order |
|---|---|---|
| 4 mil, blue (100/box) | General examination and short procedures | 4.0 mil nitrile exam gloves, 1,000 per case |
| 6 mil, black (100/box) | Heavy-duty handling, higher puncture risk | 6 mil Black, 100-Pack |
| Case of 10 boxes | Sites going through gloves daily — lowest cost per glove | Wholesale Case, 1,000 Gloves |
| Chemo-grade 4.0 mil | Any handling that may involve cytotoxics | Chemo-Grade, 100-Count |
| Starting a clinic? | Gloves plus spore testing plus packaging in one order | Clinic Starter Bundle |
Ontario and GTA orders ship free over $99; elsewhere in Canada over $199 ($15 flat below). Bulk and standing orders go through a wholesale account. Print a blank sterilization log sheet from our free generator, or book a sterilization compliance review.
| Size | Palm Width (inches) | Palm Width (mm) | Hand Length (mm) | Recommended Hand Circumference |
|---|---|---|---|---|
| XS | 2.9 – 3.1" | 74 – 79 mm | 220 – 240 mm | ≤ 7" (178 mm) |
| S | 3.1 – 3.5" | 79 – 89 mm | 240 – 260 mm | 7 – 8" (178 – 203 mm) |
| M | 3.5 – 3.9" | 89 – 99 mm | 260 – 280 mm | 8 – 9" (203 – 229 mm) |
| L | 3.9 – 4.3" | 99 – 109 mm | 280 – 300 mm | 9 – 10" (229 – 254 mm) |
| XL | 4.3 – 4.7" | 109 – 119 mm | 300 – 320 mm | 10 – 11" (254 – 279 mm) |
Note: Sizing may vary slightly between manufacturers. Always verify against the supplier's spec sheet. ASTM D6319-19 sets minimum length and palm width requirements — any glove meeting these tolerances is compliant for medical examination use in Canada.

How to Measure Your Team for Glove Sizing
When procuring gloves for an entire clinic, don't guess sizes. Here is the standard method:
- Measure palm width: Wrap a measuring tape around the widest part of the dominant hand (across the palm, below the knuckles, excluding the thumb). Record the circumference.
- Measure hand length: From the tip of the middle finger to the base of the palm.
- Cross-reference both against the chart above. If measurements fall between sizes, size up for better comfort during extended wear.
For bulk procurement, order a size distribution based on your staff profile. A typical primary care clinic orders roughly: 15% S, 40% M, 35% L, 10% XL. Adjust based on your team's actual hand measurements.
Canadian Compliance Requirements
Under Health Canada's Medical Devices Regulations (SOR/98-282), medical-grade nitrile gloves must carry a Medical Device License (MDL). This ensures the glove meets ASTM D6319 for barrier performance, tensile strength, and puncture resistance. Industrial-grade nitrile gloves — often cheaper — are not licensed for medical examination use and should not be used in clinical environments.
Key specs to look for on your spec sheet:
- ASTM D6319 compliant — medical examination grade
- AQL ≤ 1.5 — acceptable quality limit for pinholes (lower is better)
- Minimum tensile strength: 14 MPa before aging, 10 MPa after aging
- Minimum thickness: 0.05 mm (palm), 0.06 mm (finger)
Common Procurement Mistakes
Buying one size fits all: Gloves that are too tight cause hand fatigue and tearing; too loose compromises dexterity and barrier protection. Always offer multiple sizes.
Ignoring length: Standard exam gloves are 9.5" (240 mm) long. For procedures with splash risk, consider 12" gloves.
Skipping the spec sheet: Not all "nitrile" gloves are medical grade. Verify ASTM D6319 compliance and Health Canada MDL number before purchasing.
CliniEco Medical supplies nitrile gloves across Canada. Contact us for bulk pricing.
Related Reading
Explore more guides in this category:
- AQL Explained: Medical Glove Quality Standards for Buyers
- EN 455 vs ASTM D6319: Exam Glove Standards Compared
- Nitrile Gloves for Canadian Food Processing: Safety Standards and Regulatory Requirements
Also read: see whether nitrile gloves are food safe in our gloves pillar guide.
Monitoring your sterilizer? Pick the BI format that matches your workflow.
Ontario dental offices must run a biological indicator every day the sterilizer is used (RCDSO). Choose the readout speed that fits your schedule:
- 24-hour self-contained BIs — 25, 50 and 100-count packs for daily monitoring
- 1-, 3- and 20-minute rapid-readout BIs — same-day release when you cannot wait overnight
- 4-well fluorescence reader — incubates and reads rapid-readout BIs in one bench instrument
Shop 24-hour biological indicators Shop the 24-hour readout BI 50-pack
Frequently Asked Questions
What size mix should a clinic keep on the shelf?
Stock to the hands you actually have rather than to an even split. Most teams settle on roughly two boxes of medium for every box of small and every box of large, with extra-large held in a single box that is reordered only when it empties. Ordering equal quantities of every size is the usual reason one size sits unopened while another runs out mid-week. CliniEco Medical stocks that case format: the 3.5 mil standard blue case of 1,000 covers a small practice for a month at typical chair-side use.
How do you measure a hand for nitrile gloves?
Measure the circumference around the widest part of the palm, just below the knuckles, without including the thumb. Compare that number against the supplier's published chart rather than against a size printed on a glove from another brand, because sizing tolerances differ between manufacturers even when both cite the same standard. When a measurement lands between two sizes, take the larger one for procedures that run long, since a glove that is too tight at the palm fails at the cuff first.
Do the same size letters mean the same dimensions across brands?
No, and this is where a glove order goes wrong. ASTM D6319 sets performance requirements for nitrile examination gloves, but it does not fix a universal width for the letter M. A team that switches supplier and keeps the same size letters will find the fit has moved. The fix is to keep one box of the outgoing brand until the new size is confirmed on two or three hands, then commit to the case. Heavier films behave differently again: the 6 mil heavy-duty black case fits more snugly at the same letter because the film has less stretch.
Which case configuration makes sense for a first order?
Start with one case of the working film and a single box of anything heavier, then let the reorder pattern decide. A clinic that goes through gloves daily should be buying by the case rather than the box, because the case is the unit the supplier ships and the unit that keeps the price stable. Where several films are in use at once, the INTCO wholesale case of 1,000 and the Aurelia Robust 4.5 mil both ship in the 10-box format that stacks in a cupboard without repacking.
CliniEco Medical · Health Canada MDEL #35334 · Request a wholesale quote