Clinical HPLC Systems in Canada vs the US: Which Class Applies?

Stacks of birch wood tongue depressors banded in paper beside a loose pile

Quick facts

  • A clinical HPLC system separates the components of a sample in a liquid stream so that an analyte can be measured, using a pump, a column and a detector.
  • In the United States it is filed under 21 CFR 862.2260, High pressure liquid chromatography system for clinical use, at Class I, product code LDM.
  • In Canada the system is a non-invasive device at Class I under Rule 7(1) of the Medical Devices Regulations.
  • Rule 7(2) raises it to Class II if it is intended as a calibrator, tester or quality control support to another device, or if it is connected to an active device already classified II, III or IV.
  • Where the system is used only to run an IVD assay, the assay and its reagents carry their own class under Part 2 of Schedule 1, separate from the equipment itself.
  • Entries and rule text were checked against the current eCFR text, the Regulations and the openFDA classification database on 2026-10-11.

A clinical HPLC system pumps a liquid sample through a column and measures what comes out, so that a clinical analyte can be identified and quantified. In the United States it is a named Class I entry; in Canada the equipment is a non-invasive device whose class depends on how it is used and what it is joined to. This article sets out both routes, separates the equipment from the assay that runs on it, and lists the standards a laboratory reads when it specifies a system.

What is a clinical HPLC system?

High pressure liquid chromatography drives a liquid mobile phase through a packed column under pressure. Different components of the sample travel at different speeds and reach the detector at different times, so a peak on the trace can be tied to an analyte. A clinical system is the version of that instrument used to produce a result a clinician acts on, and it is normally made up of a pump, an injector, a column, a detector and the software that turns the signal into a number.

The equipment and the test are two separate things in both countries. The system is a piece of laboratory equipment; the reagent kit and the assay run on it are in vitro diagnostic devices with their own classification. A laboratory that buys the instrument and the assay should expect to look up two different answers.

Is a clinical HPLC system a Class I device in the United States?

Yes. 21 CFR 862.2260 names a High pressure liquid chromatography system for clinical use and classifies it at Class I (general controls). The openFDA device classification API lists the system under product code LDM, with related codes such as KIE for the apparatus, DPM for liquid chromatography columns and LEQ for electrochemical detectors.

A Class I device of this kind reaches the market under general controls and registration rather than a per-device premarket review. That is the equipment side of the US answer. The assay that the laboratory runs on the system is a different device with a different entry and, very often, a different class.

How does Canada classify a clinical HPLC system?

Canada treats the instrument as equipment rather than as a diagnostic device. The system does not enter the body and does not contact the patient, so it is a non-invasive device and Rule 7(1) of the Medical Devices Regulations applies, placing all other non-invasive devices at Class I.

Rule 7(2) then asks two questions. Is the system intended to act as a calibrator, tester or quality control support to another medical device? And is it intended to be connected to an active device that is itself classified II, III or IV? A stand-alone bench system answers no to both and stays at Class I. A system delivered as part of a larger instrumented analyser may answer yes, and the class rises with the device it is tied to.

Item Canada United States
Named entry None; classified by rule 21 CFR 862.2260, HPLC system for clinical use
Product code Not applicable LDM (KIE, DPM, LEQ related)
Default class Class I (Rule 7(1)) Class I (general controls)
Lift to Class II Rule 7(2)(a) or 7(2)(b) Not by class
Equipment route Establishment licence; no device licence for Class I General controls; registration and listing
Assay route IVD rules, Part 2 of Schedule 1 IVD entry for the assay

Does the assay on a clinical HPLC system have its own class?

Yes, and it is separate from the instrument. Once a laboratory uses a reagent kit to produce a diagnostic result, that kit is an in vitro diagnostic device and is classified under Part 2 of Schedule 1 of the Medical Devices Regulations. Part 2 is written around use rather than equipment: a test for a transmissible agent, a test used for patient management and a test used in diagnosis each have their own rule and their own class.

What is being classified Canada United States
The HPLC instrument Non-invasive equipment, Class I (Rule 7(1)) Device at 862.2260, Class I
A reagent kit run on the instrument IVD, Part 2 of Schedule 1 IVD entry for the kit
Software that reports a clinical result Read with its intended use Read with its intended use
A column sold as a consumable Read with its intended use Consumable under the system entry

The rule to carry away is that the equipment and the assay are classified separately. A purchasing team that reads only the 862.2260 entry has the equipment answer and not the assay answer, and it is the assay that a laboratory licence is usually built around.

Which standards apply to a clinical HPLC laboratory?

The class says what the device is; the standards say how the laboratory must work. ISO 15189:2022 sets out what a medical laboratory must do to demonstrate quality and competence, and it is the frame that turns an instrument log into evidence. Where a manufacturer builds the system to a management system it works to ISO 13485:2016, and the risk file follows ISO 14971:2019.

For method detail, the laboratory reads the Clinical and Laboratory Standards Institute documents, which carry the validated-method material a chromatographic procedure is written against. In Canada, Public Health Ontario carries the wider laboratory safety and quality material.

How does a laboratory specify and record an HPLC system?

Specify by the analytes the laboratory runs, by the column format and by the detector. A bench that runs one panel is well served by a small isocratic system; a laboratory that runs several panels with different chemistries needs a gradient system and a column library. The specification should also name the software that reports the result, because the software's intended use is read with the device.

Record by the run. The consumables that travel with a chromatography bench - graduated sample cups for the specimen as it arrives, cotton swabs for bench cleaning and individually wrapped swabs where a single sterile swab is needed - are restocked as a set, and the bench keeps its method and instrument log beside them. Multi-site groups order at case level through the wholesale and multi-site ordering page and the B2B wholesale collection. Reselling? become a distributor.

Stacks of birch wood tongue depressors banded in paper beside a loose pile Graduated plastic specimen container with a screw cap on a dark background

Sources

  1. openFDA device classification API
  2. Medical Devices Regulations, SOR/98-282, full text and Schedule 1
  3. US FDA, medical devices
  4. US FDA, medical device databases
  5. US FDA, overview of device regulation
  6. Health Canada, medical devices
  7. Health Canada, establishment licensing
  8. Standards Council of Canada
  9. CSA Group
  10. ISO 13485:2016, medical devices quality management
  11. ISO 14971:2019, risk management of medical devices
  12. CCOHS, OSH answers
  13. Clinical and Laboratory Standards Institute
  14. Public Health Ontario, infection prevention and control
  15. ISO 15189:2022, medical laboratories, requirements for quality and competence
  16. US CDC, laboratory quality
  17. World Health Organization
  18. 21 CFR 862.2260, High pressure liquid chromatography system for clinical use
  19. Clinical and Laboratory Standards Institute
  20. Public Health Ontario, infection prevention and control

A chromatographic method only counts as evidence if the run is written down. The printable blank run sheet at the compliance log centre carries columns for the instrument, the column, the calibration and the reviewer, and it opens in the browser for printing without an account and no sign-up.

Where a bench runs the same panel many times a week, the method and run log generator on that page lays out a sheet sized to the number of instruments and shifts in the laboratory.

Have a question about your own facility? Send it in and you will get a written answer specific to your setup, with the regulation or standard it is based on cited. Ask a compliance specialist about your equipment and province.

Related reading

CliniEco Medical supplies eye care, laboratory and dental consumables of the kind described in this article. MDEL #35334. This article is written for optometry, laboratory and dental procurement professionals and is not legal advice; the class of a device and the records kept by a practice belong to the manufacturer and to the requirements that apply to it.

Frequently Asked Questions

Is a clinical HPLC system a Class I device?

In the United States it is Class I under 21 CFR 862.2260, High pressure liquid chromatography system for clinical use. In Canada it is a non-invasive device at Class I under Rule 7(1).

When does an HPLC system become Class II in Canada?

Under Rule 7(2). It becomes Class II if it is intended to act as a calibrator, tester or quality control support to another medical device, or if it is intended to be connected to an active device already classified as Class II, III or IV.

What is the US product code for a clinical HPLC system?

The openFDA classification database lists Instrumentation, High Pressure Liquid Chromatography under product code LDM within regulation number 862.2260 at Class I.

Is the assay run on the system also Class I?

Not necessarily. The reagent kit is an in vitro diagnostic device and is classified under Part 2 of Schedule 1 in Canada and under its own entry in the United States; its class depends on how it is used, not on the instrument.

Does a Class I HPLC system need a device licence in Canada?

No. A Class I device needs no device licence of its own; the manufacturer holds an establishment licence and keeps the records the Regulations require. A Class II or higher device needs a licence under section 32.

Which standard frames a clinical HPLC laboratory?

ISO 15189:2022 sets the requirements for quality and competence in a medical laboratory. ISO 13485:2016 covers a manufacturer's quality system and ISO 14971:2019 the risk file.

How should a chromatography run be recorded?

With the instrument, column, calibration and reviewer, in a method sheet the laboratory keeps. The compliance log centre provides a printable blank run sheet and a log generator sized to the laboratory.

Already working with clinics? Become a regional representative.