An infection control auditor does not arrive looking for a glove brand. The audit trail is made of decisions: which glove was selected for which task, whether hands were cleaned before and after, how a box was stored between clinics, and what happens when a staff member reports a latex allergy. Those decisions are written down either in a policy that staff follow or in a finding that the clinic has to answer.
This page sets out what a Canadian auditor checks on gloves, what the current Ontario guidance actually requires, and where the Canadian and American positions on the device itself differ. The gloves used through a clinic day are ordinary consumables: a 3.5 mil standard nitrile examination glove for routine contact and a 6 mil heavy-duty nitrile glove where the task is wetter or longer.
Quick facts on glove audits in Canadian clinics
- Gloves are indicated when hands will contact mucous membranes, non-intact skin, tissue, blood, body fluids, secretions, excretions, or surfaces contaminated with them.
- Gloves are not indicated for contact limited to intact skin, such as taking a blood pressure or dressing a patient.
- The same pair must not be used for more than one patient, and gloves must not be washed or re-used.
- All medical gloves sold in Canada are Class II medical devices under the Medical Devices Regulations; there is no separate non-medical route to market for a clinic glove.
- In the United States a non-powdered patient examination glove is a Class I device, but only a finger cot is exempt from premarket notification.
- An auditor can ask for the glove specification, the supplier's establishment licence number, and the training record that shows staff were taught when not to wear gloves.
What does a Canadian infection control auditor check about glove use?
The starting document in Ontario is the Provincial Infectious Diseases Advisory Committee guidance on routine practices, most recently reissued in June 2025. Its language is written as a duty rather than a preference: gloves must be worn when it is anticipated that the hands will be in contact with mucous membranes, non-intact skin, tissue, blood, body fluids, secretions, excretions, or equipment and environmental surfaces contaminated with any of those. An auditor reading a clinic's policy is checking whether that sentence has been translated into a task list for the rooms the clinic actually runs.
The second half of the same guidance is what clinics tend to forget, because it describes restraint rather than protection. Gloves are not required for routine activities where contact is limited to intact skin. Taking a blood pressure, bathing a patient, dressing a patient, or moving a chair are all examples given. Indiscriminate glove use is treated as a finding in its own right, because it wastes stock, reduces hand hygiene compliance, and has been linked to transmission when staff wear the same pair from one task to the next.
Three specific behaviours are usually tested by observation rather than by document review. The first is sequencing: gloves go on immediately before the task, and come off immediately after it, before touching clean surfaces. The second is hand hygiene: hands are cleaned before donning for an aseptic procedure and immediately after removal. The third is the boundary rule: a change of gloves is required when moving from a contaminated site to a clean site on the same patient, and a new pair is required for the next patient without exception.
| Glove question an auditor asks | What the answer has to show | Common finding |
|---|---|---|
| Is the glove appropriate to the task? | A written task-to-glove table covering examination, cleaning, and sterile procedures | One glove type issued for every task, including cleaning |
| Is the fit checked? | More than one size stocked and a stated sizing method | Single size per room, staff double-gloving to compensate |
| Is the glove compatible with hand hygiene products? | Manufacturer statement or a documented compatibility check | Alcohol-based rub used with a glove the maker has not evaluated |
| Is there an alternative for latex allergy? | Latex-free stock plus a stated accommodation route | Powdered latex in use with no alternative on the shelf |
| Is glove use audited? | Hand hygiene and glove compliance observations with dates | Training records only, no observation data |
When should gloves not be worn?
The clean answer is that gloves are a task-specific barrier, not a second skin. Guidance treats them as single-use for the task in hand, and explicitly warns against washing or re-using them. Re-use has been associated with transmission of methicillin-resistant Staphylococcus aureus and Gram-negative bacilli, which is why an auditor will treat a box of washed gloves on a drying rack as a direct finding rather than a housekeeping note.
There is a practical cost argument on the same point. A clinic that gloved for every contact uses several times the stock of a clinic that gloves by indication, and it also trains staff to associate gloves with safety rather than hand hygiene. The guidance puts hand hygiene compliance ahead of glove use as the first consideration, and notes that staff may be less likely to wash their hands when wearing gloves for routine tasks. For a laboratory or a procedure room, that is the behavioural risk the audit is designed to catch.
What does an auditor check about glove storage?
Storage is checked because it decides whether the glove in the box is the glove that was specified. Four items come up repeatedly. First, the box should be closed and kept in a clean, dry area away from sinks and splash zones, because a damp cardboard dispenser is a contaminated dispenser. Second, stock should be rotated so that the oldest lot is used first, which means the lot code has to remain legible on the box. Third, gloves should not be decanted into unlabelled containers: once the manufacturer's box and lot are gone, the clinic can no longer show what it issued or when it expires.
Fourth, and most often missed, the storage decision has to account for the hand hygiene products in use. The provincial guidance asks clinics to verify with the glove manufacturer that gloves are compatible with the hand hygiene products used in the setting, and to remove rings and keep nails short where gloves are worn for long periods. A compatibility statement is therefore part of the purchasing file, not a detail for the infection control committee to reconstruct later.
For a clinic that buys in case quantity, the practical control is a labelled shelf position per size with a reorder trigger written on the shelf edge. A case of 1,000 nitrile examination gloves is the unit most clinics plan against, and the audit question is simply whether the size mix on the shelf matches the size mix of the staff working that week.
How does the Canadian glove requirement differ from the United States?
The device rules diverge before the clinic ever sees the box. Health Canada's medical glove page states plainly that in Canada all medical gloves are classified as Class II medical devices, and that non-medical gloves are not subject to the Medical Devices Regulations and should not be mistaken for medical gloves. That means a clinic glove needs a device licence and the supplier needs an establishment licence to import or distribute it.
The American position is layered. A non-powdered patient examination glove is a Class I device under 21 CFR 880.6250, and the exemption from premarket notification applies only when the device is a finger cot. A non-powdered surgeon's glove is a Class I device under 21 CFR 878.4460. Class I in the United States is therefore not a synonym for unregulated: the examination glove still goes through premarket review unless it is a finger cot, and both types carry general controls including labelling and complaint handling.
| Item | Canada | United States |
|---|---|---|
| Device class for an examination glove | Class II for all medical gloves | Class I under 21 CFR 880.6250 |
| Premarket route | Medical device licence application to Health Canada | 510(k) premarket notification; only a finger cot is exempt |
| Supplier authorisation | Establishment licence for import or distribution | Establishment registration and device listing |
| Use requirement in health care | Provincial routine practices guidance, plus provincial occupational health law | OSHA Bloodborne Pathogens Standard, 29 CFR 1910.1030 |
| Gloves for intact-skin contact | Not indicated under provincial routine practices guidance | Not required by the bloodborne pathogens standard, which is triggered by exposure risk |
| Labelling language | English or French, with both where the province requires it | English |
What records should be ready on inspection day?
A glove finding is almost always a documentation finding. The clinic that can produce four documents in ten minutes usually closes the topic: the current glove policy with its review date, the task-to-glove table that staff actually use, the training record for each staff member including the part about when not to wear gloves, and the product file with the manufacturer's instructions and the supplier's establishment licence number. A fifth document, the hand hygiene observation log, is what turns a policy into evidence.
The occupational health side runs in parallel. In Ontario the employer duty to take every precaution reasonable in the circumstances for the protection of a worker sits in the Occupational Health and Safety Act, and a needlestick or exposure incident involving gloves is handled under the same program as sharps. Auditors increasingly ask for the exposure control plan as a single document that covers gloves, sharps, and spill response together, because the three fail together.
What does a practical glove walk-through look like?
Walk the clinic the way a patient does, and score what is in front of you rather than what is written. Start at the hand hygiene station: is product available at the point of care, and is there a glove dispenser within reach without touching a door handle. Move to the procedure room and check whether the size range on the wall matches the staff working. Then open one box and read the lot code and the expiry or manufacture date. Finish at the storage cupboard and confirm that the stock is off the floor, dry, and rotated.
Two observations close the loop. The first is a spot check of the glove that is actually being worn: a glove that has been on for an hour across three tasks has already failed the task-specific rule, regardless of what the box says. The second is the waste stream, because gloves that were never indicated end up in biomedical waste bags and change the clinic's waste cost as well as its audit result.
How do you prepare a glove file that survives a second audit?
Build the file once, in the order an auditor reads it, and update three fields a year: the policy review date, the stock list with lot codes, and the training roster. Keep the supplier's establishment licence number on the first page of the purchasing file, because that is the question that stops an audit when it cannot be answered. Then keep the observation data separate and current, since a policy with no observations reads as an intention rather than a practice.
Reviewing a glove file before an audit? Send the current task-to-glove table and the size mix by room, and the answer will flag where the policy and the shelf disagree. Ask a Compliance Specialist.
The load records, hand hygiene logs and inspection checklists that an auditor asks for can be printed from the compliance log centre, which also carries the sterilization log generator used for load release records.
Equipping several sites from one purchase order? The institutional account enquiry page covers case quantities and account setup. Reselling? become a distributor.
Related reading
- How blood-stained gauze is classified in Canadian clinic waste
- How long a sterile pack stays sterile in a Canadian clinic
- What an auditor checks about instrument reprocessing
Sources and version notes
- Provincial Infectious Diseases Advisory Committee, Routine Practices and Additional Precautions in All Health Care Settings, June 2025 — checked 14 November 2026.
- Health Canada, medical gloves — checked 14 November 2026.
- Medical Devices Regulations, SOR/98-282, consolidated text — checked 14 November 2026.
- 21 CFR 880.6250, non-powdered patient examination glove — checked 14 November 2026.
- 21 CFR 878.4460, non-powdered surgeon's glove — checked 14 November 2026.
- 29 CFR 1910.1030, bloodborne pathogens — checked 14 November 2026.
- Canadian Centre for Occupational Health and Safety, health care workers and bloodborne pathogens — checked 14 November 2026.
- Occupational Health and Safety Act, R.S.O. 1990, c. O.1 — checked 14 November 2026.
- CSA Z314:23, Canadian medical device reprocessing in all health care settings — checked 14 November 2026.
- World Health Organization, medical devices — checked 14 November 2026.
Frequently Asked Questions
Are gloves required for every patient contact in a Canadian clinic?
No. Provincial routine practices guidance requires gloves when hands will contact mucous membranes, non-intact skin, tissue, blood, body fluids, secretions, excretions or contaminated surfaces, and states that gloves are not required where contact is limited to intact skin.
Can a clinic wash and re-use examination gloves?
No. The guidance states that gloves are task-specific and single-use for the task, and that they must not be washed or re-used. Re-use has been associated with transmission of resistant organisms.
Is a medical glove a Class II device in Canada?
Yes. Health Canada states that all medical gloves distributed and sold in Canada are classified as Class II medical devices, and that non-medical gloves are not subject to the Medical Devices Regulations.
Is a patient examination glove exempt in the United States?
Only when it is a finger cot. Under 21 CFR 880.6250 the non-powdered patient examination glove is a Class I device, and the exemption from premarket notification applies to the finger cot form.
How should gloves be stored between clinics?
Closed, dry, off the floor, and rotated so the oldest lot is used first, with the manufacturer's box and lot code intact. Decanting gloves into unlabelled containers removes the traceability an auditor asks for.
Who supplies the establishment licence number?
The importer or distributor. In Canada the establishment licence covers the establishment, not the individual product, so a clinic should be able to name the licence holder for the gloves it buys.
This article cites guidance and regulations as published at the time of writing and does not reproduce them in full. Provincial requirements vary; confirm the rule that applies to your jurisdiction before changing a policy. This article is for information and is not legal advice. CliniEco Medical distributes medical consumables under MDEL #35334.