A three-room Toronto clinic was changing exam table paper four times a day per room and still running out, while the store room held three different roll widths bought by three different people. The problem was not the paper. It was that no one had measured the tables, so each room used a different width and the loose margin was being cut off and thrown away. After measuring the tables and standardising on one pre-perforated 18 inch exam table roll, the clinic cut paper use by roughly a quarter and stopped the store room from holding three part-used cases.
Here is what the clinic measured, what it changed, and where the saving actually came from.
What did the clinic measure first?
| Measurement | Finding | Change made |
|---|---|---|
| Table width | Two rooms shared a width; one was wider | Standardised two rooms, ordered one wider roll for the third |
| Sheets per patient | Averaged three, not one | Pre-perforated sheets, one per patient with a second only if needed |
| Cut off margin | Roughly a fifth of each sheet | Matched roll width to table width |
| Store room stock | Three part-used cases | One width, one case count, one holder |
Why did pre-perforated paper change the routine?
Because it removed the decision. With a plain roll, staff pull what looks right, and on a busy morning that is more than needed. A perforated roll tears at a set length, so the sheet is the same every time and the count per patient stops drifting. The clinic also fixed the holder to the wall in each room so the roll could not be taken to another room and replaced with a different width.
Where did the saving actually come from?
Three places, in order of size. The margin that used to be cut off, which the width match removed. The extra sheets per patient, which the perforation removed. And the store room, where holding one case instead of three reduced the amount of paper that aged out or was damaged in storage. The paper itself did not get cheaper; the clinic simply stopped using more of it than the table needed.
What would the clinic do differently?
Measure the tables in the first week rather than the third month, and put the measurement on a card fixed to the wall beside the holder. It would also involve the person who orders stock, because the store room had three widths precisely because reordering was done by whoever noticed the roll was low. One owner for consumables is what keeps the standard from drifting back.
Make it repeatable: print the compliance log templates, use the same page as your free log generator, and ask a compliance specialist when a result is unclear.
Ordering for a clinic, lab or care home? Wholesale and multi-site ordering covers case pricing and account setup, and the B2B wholesale collection lists the lines stocked for institutional buyers. Reselling? become a distributor.
Related reading
Underpads 60x90 vs 30x36: which size for facility beds · How many gloves a care home uses per bed per month · Clinic supply planner
Frequently Asked Questions
How often should exam table paper be changed?
Once per patient as a minimum, with a second sheet only where the contact requires it. Matching the roll width to the table removes most of the waste.
Do perforated rolls reduce paper use?
Yes. Perforations set a consistent sheet length, which stops staff from pulling more paper than the table needs.
Why does roll width matter?
A roll wider than the table creates a margin that is cut off and discarded. Matching the width to the table removes that waste.
How many roll widths should a clinic stock?
As few as possible. Standardise on one width for identical rooms and hold a second width only for a genuinely wider table.
CliniEco Medical is a licensed medical device establishment (MDEL #35334).
0 commentaire