Bowie-Dick Test Packs Compared: Which to Order in Canada

CliniEco Bowie-Dick test pack ISO 11140-5 Type 2 six-pack

Bowie-Dick Test Packs Compared: 3M Comply, Crosstex and Open Options

A 3M Comply Bowie-Dick test pack (1233LF, 6 per pack) lists at $67.49 at 3Z Dental and $73.50 at Pedicare.ca — about $11.25 to $12.25 per test. A Crosstex AirView II pack works out to $5.18 each in a 30-pack case, refill test cards in Canada list near $4.73 each, and CliniEco's ISO 11140-5 Type 2 test pack is $14.99 for six, or $2.50 per test. The test itself is identical in purpose on every line: it proves the pre-vacuum sterilizer can remove air before steam arrives. What differs is the format, the price per test, and what you have to keep on the shelf.

This is the daily check that catches air leaks, blocked drains and pump faults — the failures that a temperature and pressure readout will happily report as normal. It is worth 30 seconds of a sterilizer technician's attention and a line on the daily log.

What a Bowie-Dick Test Does, and What It Does Not

A Bowie-Dick test is a Class 2 indicator under ISO 11140-1, with the specific requirements for air-removal indicators in ISO 11140-5. It is run in an empty chamber on a pre-vacuum (Class B) sterilizer, before the first load of the day, using the cycle and exposure time stated in the sterilizer's instructions for use — commonly 134 °C for 3.5 minutes.

What it proves: air was removed from the chamber and steam penetrated uniformly. What it does not prove: that the load is sterile. A Bowie-Dick test passes nothing and releases nothing; it tells you the sterilizer is fit to run loads that day. Sterility assurance still comes from the biological indicator programme — and in Ontario, the RCDSO requires a biological indicator for each sterilizer on every day that it is used, daily monitoring rather than weekly, with the weekly baseline being the CDC / AAMI ST79 standard in most US states.

Three Formats, Three Budgets

Canadian clinics buy Bowie-Dick testing in one of three shapes, and they are not priced alike.

  • Single-use test pack. A pre-assembled pack that simulates a standard towel pack. Open it, run it, read the sheet, file it. Nothing else to buy, nothing to clean.
  • Test card or sheet plus a holder. A card that goes into a reusable holder or a clinic-assembled towel pack. Lower cost per test, but the holder is a capital item and the assembly is a documented procedure.
  • Electronic system. A reader-based Bowie-Dick that returns a pass or fail result with the record attached. Higher capital cost, and the consumable is tied to that reader.

Bowie-Dick formats: pack, card and electronic

Print this table and keep it at the sterilizer. Print this table

Format What it tests Cycle it belongs to Consumable
Single-use pack Air removal and steam penetration in a porous load Pre-vacuum cycle, first cycle of the day One pack per test day
Card or sheet with a holder The same air-removal check in a card format Pre-vacuum cycle A card plus a reusable holder
Electronic test Chamber air removal logged by the sterilizer Pre-vacuum cycle No consumable; a stored printout
Gravity-displacement cycle No Bowie-Dick test applies Gravity cycles Use a biological indicator

A Bowie-Dick test checks air removal in a pre-vacuum cycle; it is not a sterility test and does not replace the biological indicator. Run it on the first cycle of the day, keep the sheet, and investigate a fail before releasing the load.

Price Comparison

List prices below were checked on 11 September 2026 at the named suppliers. Currency is Canadian dollars unless the source is marked as a US reseller.

Product Format Pack List price Per test
3M Comply 1233LF Test pack 6 per package $67.49 CAD $11.25
3M Comply 1233LF Test pack 6 per package $73.50 CAD $12.25
Crosstex AirView II Test pack 30 per case $155.40 USD $5.18
Crosstex Bowie-Dick test sheet Sheet, needs towel pack 50 per pack $46.62 USD $0.93
ValueTest BD refill card Card, needs holder 30 per package $141.92 CAD $4.73
Chemdye BD test card Card, needs holder 120 per box $353.21 CAD $2.94
Lantor Cube reusable pack Reusable pack 25 per case $357.93 CAD $14.32 per cycle
CliniEco Bowie-Dick test pack Test pack, ISO 11140-5 Type 2 6 per pack $14.99 CAD $2.50

Read the table with two cautions. First, "per test" is only comparable inside a format: a $0.93 sheet requires a towel pack or a holder to function, so it is not a $0.93 test. Second, the reusable pack is priced per cycle over its service life, not per purchase, which is a different procurement conversation from a box of packs.

The Cost of a Year of Daily Checks

One pre-vacuum sterilizer, tested once on each day it runs — 250 days a year — is 250 tests.

Approach Per test Per year Three years
3M Comply 1233LF $11.25 $2,813 $8,438
Crosstex AirView II $5.18 $1,295 $3,885
ValueTest card plus holder $4.73 $1,183 $3,548 plus holder
CliniEco test pack $2.50 $625 $1,875

The gap between the priciest single-use pack and the lowest is about $2,188 a year on one sterilizer. That is real money, and it comes out of a consumable that has no clinical difference in what it tells you: either the air was removed or it was not.

CliniEco Bowie-Dick test pack, ISO 11140-5 Type 2, 6-pack for daily pre-vacuum air removal checks

Choosing Between Pack, Card and Electronic

Three questions settle it for most clinics.

  1. How many pre-vacuum sterilizers do you run? At one or two, a single-use pack removes assembly and cleaning steps that a small team cannot reliably document. At five or more, a card-and-holder system or a reusable pack starts to pay.
  2. What does your sterilizer manual specify? Some manufacturers name the test method, the exposure time and the chamber configuration. Follow the manual, not a distributor's bundling.
  3. How do you file the result? Every format produces a record; the question is whether it is scannable, stapled or photographed into your log. Pick the format your team will actually file, because an undocumented daily check is indistinguishable from no check.
CliniEco autoclave indicator tape, three-roll set used to seal packs alongside daily Bowie-Dick testing

Where CliniEco Fits

CliniEco Medical supplies a Bowie-Dick test pack to ISO 11140-5 Type 2 at $14.99 for six tests — $2.50 per test — with a clear blue-to-dark irreversible pass indication, built for the 134 °C × 3.5-minute cycle and sized for benchtop Class B sterilizers. It is distributed in Canada by CliniEco Medical, Toronto, with no minimum order.

Paired with our autoclave indicator tape at $19.99 for a three-roll set and a Class 5 integrator at $19.99 per 100, a clinic covers daily air-removal checks, pack sealing and in-pack monitoring without buying into a reader platform.

CliniEco Medical is a licensed medical device establishment (MDEL #35334).

If your sterilizer runs daily, the fastest way to verify that your monitoring routine produces readable results is a 24-hour biological indicator 25-pack rather than a full case order.

Related Reading

Whichever Bowie-Dick option a clinic runs, the daily vacuum check still needs a signed record, and the log layout can be checked with a sterilization compliance specialist.

Where to Buy Sterilization Indicators and Spore Tests in Canada

CliniEco Medical supplies chemical indicators, integrating indicators and self-contained biological indicators to clinics, laboratories and care homes across Canada, shipped from Ontario.

Type What it confirms Order
Class 5 integrating indicator All critical parameters were met — used inside every pack Class 5 Integrators, 100-Pack
Biological indicator (spore test) The actual kill — the only test that proves sterilization 24-Hour, 25-Pack
Bowie-Dick test pack Air removal in pre-vacuum sterilizers only Bowie-Dick, 6-Pack
Indicator tape External process indicator — the load was processed Autoclave Tape, 3-Roll Set
Not sure which applies? Run one week in your own workflow first 24-hour biological indicator 25-pack

What Bowie-Dick test packs cost in Canada

These are live list prices, not estimates, and the per-test column is the pack price divided by the tests inside it (MDEL #35334).

Item What it confirms Pack Price (CAD) Cost per test Order
Bowie-Dick test pack (ISO 11140-5 Type 2) Daily air-removal check on one pre-vacuum unit 6-pack $14.99 $2.50 Bowie-Dick, 6-Pack
Bowie-Dick test pack (ISO 11140-5 Type 2) Same pack, case for a group or a year of checks Case of 10 (60 tests) $119.92 $2.00 Bowie-Dick, Case of 10
24-hour self-contained biological indicator The spore test a Bowie-Dick cannot replace 25-pack $69.99 $2.80 24-Hour, 25-Pack
24-hour self-contained biological indicator One bench testing every working day 50-pack $109.99 $2.20 24-Hour, 50-Pack
24-hour self-contained biological indicator Several loads a day 100-pack $189.00 $1.89 24-Hour, 100-Pack
Class 5 integrating indicator In-pack release check on the same loads 100-pack $19.99 $0.20 Class 5 Integrators, 100-Pack

Which sterilizers these fit: a Bowie-Dick test belongs to pre-vacuum (Class B) sterilizers and is run in an empty chamber on the 134 °C × 3.5-minute cycle most benchtop units specify — confirm the exposure time in your own manual. A gravity-displacement sterilizer does not take this test at all, because there is no air removal phase for it to verify, and the pack is not a substitute for the daily biological indicator on any unit.

How many packs to hold: one pack per pre-vacuum sterilizer per test day. A single sterilizer checked before its first load, five days a week, uses 5 packs a week, so the 6-pack covers about one working week and the case of ten (60 tests) covers about twelve weeks; two sterilizers halve both figures. Add a pack for every re-test that follows a failed check, and keep a spare week on the shelf so a failed result never waits on a delivery. As a formula: pre-vacuum sterilizers × test days per week = packs per week — one pack per sterilizer per day it is used, because a Bowie-Dick test is run once a day per unit and is not repeated for each cycle type.

Stock and shipping: both Bowie-Dick pack sizes ship from Toronto, Ontario, and the exact dispatch date is confirmed with you before the order is released — we do not quote a delivery date at checkout. Every indicator pack carries its lot number, so the entry in your monitoring log traces back to the batch. Ordering for a group of clinics or a distribution account? become a distributor, or use the wholesale route for a standing account.

Round Out Your Sterilization Setup

A biological indicator is one link in the chain — these are the pieces it works with:

Ontario and GTA orders ship free over $99; elsewhere in Canada over $199 ($15 flat below). Bulk and standing orders go through a wholesale account. Print a blank sterilization log sheet from our free generator, or book a sterilization compliance review.

Which sterilizers a Bowie-Dick test fits

Pre-vacuum only. A Bowie-Dick test is run on a pre-vacuum (Class B) sterilizer, in an empty chamber, before the first load of the day, at the cycle and exposure time in the sterilizer's own instructions — commonly 134 °C for 3.5 minutes. It has no role on a 121 °C gravity-displacement cycle, where there is no vacuum stage for air to be trapped by, and running one there produces a result that means nothing. Which format fits your bench: a single-use 6-pack suits one or two benchtop Class B units; a card-and-holder system pays off from about five sterilizers upward; an electronic reader ties the consumable to that reader. All three answer the same air-removal question, so pick by throughput and by what your team will actually file.

Frequently Asked Questions

How often should a Bowie-Dick test be run?

Daily, before the first load, on every pre-vacuum sterilizer. It is an air-removal test, so its purpose is to confirm the sterilizer can run loads that day. Follow your sterilizer manufacturer's instructions for the cycle and exposure time, which are commonly 134 °C for 3.5 minutes.

Is a Bowie-Dick test a substitute for a biological indicator?

No. A Bowie-Dick test confirms air removal and steam penetration in an empty chamber; a biological indicator measures whether the process actually killed spores. Both belong in a monitoring programme. In Ontario, the RCDSO requires a biological indicator for each sterilizer on every day that it is used, daily monitoring rather than weekly, with the weekly baseline being the CDC / AAMI ST79 standard most US states follow.

Why is one Bowie-Dick pack $11 and another $4?

Format and channel, not efficacy. A branded pre-assembled pack carries assembly, packaging and brand margin; a refill card in a reusable holder, or a direct-import pack sold without a distributor tier, costs less for the same class of result. Compare per test inside the same format before drawing conclusions.

Can I use a Bowie-Dick sheet without a holder?

A sheet is designed to be placed inside a standardised towel pack or a holder, because the test depends on the resistance that pack or holder presents to air removal. A loose sheet in an empty chamber does not reproduce that challenge, so the result is not a valid Bowie-Dick test.

Do gravity displacement sterilizers need a Bowie-Dick test?

No. The test checks active air removal, so it applies to pre-vacuum (Class B and similar) sterilizers. A gravity displacement sterilizer removes air by displacement, and its monitoring follows a different schedule in your sterilizer manual and your regulator's guidance.

CliniEco Medical is a licensed medical device establishment (MDEL #35334). Competitor prices are list prices published by the named suppliers on 11 September 2026 and are included for comparison only; currency is noted per row. This article is general information for Canadian healthcare buyers and does not replace the guidance of your regulator, infection-control officer or sterilizer manufacturer. Last updated: 11 September 2026.

Related reading

Already working with clinics? Become a regional representative.