Use the planner on this page to work out how many incontinence products your facility needs each month, and what that costs. Enter the number of residents, the average number of changes per day, and the product you use. Change any figure to match your own routine.
Estimates use planning assumptions, not clinical advice. Prices are our website retail prices in CAD and exclude tax and shipping. Orders are placed in whole packs or cases.
How many briefs does one resident use in a month?
Plan from changes per day, not from absorbency. The number of products a resident uses is set by how often their care plan says to check and change them, which in turn follows mobility, output and skin condition. Multiply changes per day by the days in the month, and multiply again by the number of residents at that level of need. The day-comfort brief is the form most units start with at the moderate level.
The planning range most facilities start from is three to four changes a day for a resident who is mobile and manages their own toileting, five to six for a resident who needs assistance to transfer, and six to eight for a resident who is bedbound or on a repositioning schedule. Those are planning figures, not clinical standards: your own continence and skin care policy is the authority, and the estimate should be corrected against actual draw-down after the first full month.
Two facilities of identical bed count can differ in monthly volume by more than half on this calculation alone, which is why a per-bed average copied from another home is usually wrong and why the planner asks for the change frequency rather than a headcount.
| Level of need | Changes per day (planning range) | Usual form | What the monthly count depends on |
|---|---|---|---|
| Mobile, self-managing | Three to four | Pad or liner | Resident count x changes x days |
| Needs help to transfer | Five to six | Pad or brief | Staffing pattern as much as resident count |
| Bedbound or on a repositioning schedule | Six to eight | Brief plus underpad | Repositioning intervals |
| Extended night wear | One to two over eight or more hours | Higher-capacity brief | Nights, not days |
The table is a planning starting point. Your own continence and skin care policy sets the actual frequency, and the first month of draw-down is what corrects the estimate.
How many sizes should a facility stock, and how deep should each be?
Stock three sizes to cover the resident population and a small quantity of the two extremes. The middle sizes carry almost all of the volume, so holding them deep and the ends shallow keeps both the shelf and the order sensible. A facility that stocks six sizes evenly ends up with four under-used sizes and a chronic shortage in the one that matters.
Depth follows cover, not preference: hold about one month of the middle sizes and two to four weeks of the extremes. Re-measure on admission and on any change in weight or mobility rather than carrying a size forward from a previous facility, because published size charts are not applied consistently across brands and a brief that is one size wrong leaks at the leg cuff regardless of how absorbent the core is.
How many underpads does a facility need per month?
Underpads are counted per change for residents who are in bed, and per day for residents who are up in a chair. A bedbound resident changed six times a day consumes six underpads a day on that rule, while an ambulatory resident using a chair pad consumes one or two. That difference, not the resident count, is what makes underpad volume swing between units.
Size follows the use. A smaller pad (30 by 36 inch) is sized for chair protection and for use under a brief; a larger pad (60 by 90 cm) is sized for bed protection where the resident turns or where the brief alone is not expected to hold overnight. The size difference is covered in detail in 60 by 90 cm versus 30 by 36 inch underpads. Ordering only the large size for every purpose doubles consumption, because a large pad is placed under a resident who does not need one and then replaced at the same frequency.
Do we need both briefs and pads, or can one replace the other?
Stock both, and use the pad for the lighter need. A pad with a shaped core handles light to moderate loss in a resident who is mobile and can be changed standing, at a fraction of the product volume of a brief. A brief is the right form where loss is heavy or continuous, where the resident is not reliably mobile, or where the change has to happen without the resident standing.
The reason to keep both is not choice for its own sake. Using a brief for a light need means more product per change, more skin covered, and more time per change. Using a pad for a heavy need means a leak at the point where the pad shifts. The mix that matches each resident to the lightest form that holds is the one that keeps both the order size and the laundry volume down.
How many disposable washcloths or wipes does a change consume?
Plan one to two per change, which for a six-change day is six to twelve a day per resident. The variable is not the wipe, it is the technique: a single wipe used front to back and then folded uses less product than several wipes used in the same direction, and produces a better clean. Facilities that report running out of washcloths are often looking at a technique difference rather than a supply shortage.
Disposable washcloths remove the laundry load and the storage of damp cloths, which is why they are usually the first item a facility adds when it moves from cloth to single-use. Keep the pack sealed until the change, and keep a dry container at the point of use rather than carrying a stack from room to room.
How do I convert a large case into months of cover?
Divide the case count by monthly use. Monthly use is residents multiplied by changes per day, multiplied by thirty. A thirty-bed unit where two thirds of residents average five changes a day uses about three thousand products a month, so a four-thousand count case is roughly one and a third months of cover for that unit.
Run that division for every case size you are offered before choosing; the bulk procurement guide covers case-level purchasing for care homes in more detail. The larger case is not automatically the better buy: on a unit that consumes three thousand a month, a four-thousand case means storage for a month and a third, while a two-thousand case at twice the order frequency takes half the shelf and is replaced twice as often. If your storage is already full, the smaller case with a fixed reorder point is the better arrangement even when the larger one looks tidier on the invoice.
What safety stock should a care home hold?
Hold one to two weeks of cover on the fast movers, and lean towards the higher end for items that come from one supplier or that ship from outside the province. The purpose of safety stock is to absorb a delivery that is late, not a change in resident mix; a rise in resident acuity is a change to the order, and using buffer stock to cover it hides the real demand for a month and then produces a shortage.
Set the buffer in cases, not in abstract units, so that whoever covers a weekend shift can see whether the buffer is intact. Site and volume accounts are arranged through wholesale and facility accounts rather than one order at a time. A practical arrangement is a marked shelf that is not drawn from except when the working stock is empty, restocked on the same day each week from the incoming delivery.
How should incontinence stock be stored and rotated?
First in, first out, with the date written on the case when it is opened. Keep cases off the floor and out of direct light, and keep the storage area dry: briefs compress under weight and the adhesive tabs degrade in heat, so a stack stored beside a heating riser will fail at the tab before the core is used. Open only one case of each size at a time and keep partial packs in the resident's own storage rather than returning them to the shelf.
Rotation matters more here than in most supply categories because the product is bulky and slow to move. A case that gets pushed to the back of a shelf is not discovered until someone counts stock six months later, by which time the resident it was bought for has changed size.
How do I plan for respite beds and temporary admissions?
Add the variable beds at close to full occupancy for the length of the stay, and keep the extra separate from the permanent stock. Respite admissions arrive without a measured size, so the reserve should lean on the middle sizes and on a form that can be re-taped, which covers a size that is slightly wrong without a second product.
The number to watch is the return rate, not the consumption. An unopened case can go back on the shelf; opened packs from a two-week stay usually cannot. Ordering the respite reserve in smaller pack sizes costs a little more per unit and wastes far less when the stay ends early.
How does night-time use differ from daytime?
Night is a different product decision, not simply more of the same. Extended wear means fewer changes over a longer period, so the product needs a higher capacity core and a better seal at the leg cuff; the overnight brief is built on that assumption rather than on a larger daytime form. The failure mode is also different: a daytime leak usually means the core was full, while an overnight leak usually means the cuff was not in contact with the skin, which is a fit question rather than an absorbency question.
Plan the night stock separately from the day stock, because the two are consumed at different rates and a single combined estimate will leave the unit short of the higher-capacity form. If bedding is wet in the morning while the brief is not saturated, the answer is a fit check, not a larger case.
How do I know whether the product mix is right?
Count laundry incidents per hundred resident-days, and compare that with the volume of product being consumed. The pattern that matters is incidents rising while consumption is flat, which points at the form rather than the quantity: the resident is being changed often enough, but the product cannot hold between changes. The opposite pattern, consumption rising while incidents stay flat, points at the change schedule or at over-specification.
Both directions are worth a monthly look, because a mix that was right at admission drifts as residents change. Reviewing the mix against incidents is also the most direct way to answer a family question about whether their relative is receiving enough care, since it replaces an opinion with a count.
What records should a continence supply plan keep?
Keep four fields per resident: the product and size in use, the change frequency set by the care plan, the date the size was last measured, and any change of form with the reason. Add the lot number when stock is received so that a batch question can be answered without searching the store room. The measurement date is the field most often missing and the one that explains most size errors, because a resident who has lost weight will keep receiving the size they were admitted with until someone writes the new measurement down.
If the same site also orders wound care, gloves, disinfection and treatment-room supplies, the clinic supply and cost planner works the same way for those families, and the planner page prints a stock checklist you can take to the store room.
Review the plan monthly against the draw-down count and against incidents. A plan that is never compared with actual use is not a plan; it is a record of what someone intended in the month the resident arrived.
How do we reduce waste from opened cases and partial packs?
Open one case per size at a time, keep the partial packs in a known place, and order the fast-moving sizes in cases and the slow-moving sizes in packs. Most incontinence waste is not spoilage, it is the partial pack: three open packs of the same size in three different rooms, none of them being finished.
Two habits remove most of it. Give each resident storage for their own product, labelled with their name and the size, so partial packs follow the resident rather than the room. And at the monthly count, list opened packs separately from sealed cases, because the opened ones are what the next order should be adjusted against.
Frequently asked
How do I estimate monthly incontinence supply needs?
Multiply the number of residents by the average number of changes per resident per day, then by the number of days in the month. The estimate above does this for you and lets you change each figure.
How is the monthly cost calculated?
The estimate divides the monthly units needed by the pack or case size and rounds up to whole packs or cases, because orders are placed in whole packs. It uses our website retail prices in CAD and does not include tax or shipping.
Can we order more than one product type in the same account?
Yes. Facilities and home-care programs typically order underpads and briefs together. Volume pricing applies across the order — see wholesale and facility accounts.
Do you supply long-term care homes and home-care programs?
Yes. CliniEco Medical supplies clinics, long-term care homes and home-care programs across Canada. For account setup and volume pricing, email alina@clinieco.ca.
How do I measure a resident for adult incontinence briefs?
Measure the waist and the hip at the widest point, then order on the larger of the two numbers. If the measurement sits between two sizes, size up: a brief that is too small pulls at the leg cuffs and leaks no matter how absorbent the core is, while a brief that is one size large can be re-taped to fit. Re-measure on admission rather than carrying forward the size from a previous facility — published size charts are not applied consistently across brands.
What is the difference between light and heavy bladder leakage products?
| Leakage level | Typical form | Signals it is the right fit | Signals to step up |
|---|---|---|---|
| Light | Pant liner / thin pad | A few drops on coughing, sneezing or laughing; wearer is mobile and manages their own changes. | More than one product change in a shift. |
| Moderate | Pad with shaped core | Regular daytime loss; wearer still walks to the washroom. | Pad shifting or gathering when the wearer walks. |
| Heavy | Belted or tab-style brief | Loss is continuous or the wearer is not reliably mobile. | Skin staying damp between checks. |
| Night / extended wear | Brief with high-capacity core | Eight or more hours between changes, overnight or through a therapy session. | Morning bedding still wet. |
Which incontinence products are used after surgery?
Post-surgical leakage is usually short-term and heavier in the first days, so the form matters more than the count: a tab-style brief can be opened and re-closed for wound checks without undressing the patient, which is why it is the usual choice after prostate or gynaecological surgery. Plan a higher absorbency for the first week and step back down as volume falls — ordering a month of high-capacity product for a two-week need is the usual over-buy here.
How many incontinence pads does one resident use per day?
There is no single number: plan by change frequency, not by count. The planner takes a change frequency per resident (defaulted by mobility level) and multiplies it by residents and days, which is why two care homes of the same size can differ in monthly volume by more than half. If you are starting without history, begin with the change frequency your policy already requires and correct after one month against actual draw-down.
Why do some adult briefs control odour better than others?
Odour is produced when urine is exposed to air and bacteria, so the variables are how fast the core locks the fluid away and how much of the surface stays dry. A brief that wicks quickly and keeps fluid bound in the core will smell less than a thicker brief that holds fluid closer to the skin. This is a fabric and core question rather than an absorbency number — see our article on brief odour control for the mechanism.
Prices shown are our website retail prices in CAD and exclude tax and shipping. Estimates use planning assumptions, not clinical advice — adjust the daily change count to match your facility.
Monthly incontinence supply checklist
Print this and tick it off with your team each month. It works alongside the estimate above.
| Monthly check | ≤ 20 residents | 21–50 | 51–100 | 100+ |
|---|---|---|---|---|
| Count current stock of underpads (all sizes) | ||||
| Count current stock of briefs / pull-ons (all tiers) | ||||
| Record average changes per resident per day | ||||
| Confirm storage space and shelf dates | ||||
| Confirm who places the order and who signs off | ||||
| Re-check the estimate above against actual consumption | ||||
| Note skin-care / barrier products to reorder together | ||||
| Notes | ||||
Ordering for a facility or a home-care program?
CliniEco Medical supplies clinics, long-term care homes and home-care programs across Canada. For volume pricing and account setup, see wholesale & facility accounts or email alina@clinieco.ca.