Respiratory Care — CPAP, Oxygen & Nebulizers

Respiratory care equipment for Canadian clinics, care homes and home-care clients — fourteen listings covering CPAP parts, oxygen therapy, nebulizers, nasal irrigation, peak flow measurement and snoring devices. The collection is built around the parts that wear out as much as the machines themselves: a filter, a hose, a water chamber and a mask cushion are replaced on a cadence, and the listing you reorder from should match the device you first fitted. Power source, connection type and what each unit is supplied with are set out below.

14 products
More about Respiratory Care — CPAP, Oxygen & Nebulizers

What is in this respiratory care collection, and how is each item supplied?

Fourteen listings, grouped by what the device does. Formats and pack counts are the ones on the current listings. Several lines are shown in advance of stock, so each product page states its own current status.

Respiratory care collection: device, job and supplied format
Listing What it does Supplied as
Nasal irrigation device — sinus rinse kit Saline rinse for nasal congestion and post-nasal care One kit
Nasal rinse bottle — saline wash kit 240 mL squeeze bottle with saline sachets 1 bottle with 30 sachets; 2-kit pack
CPAP nasal pillow mask — cushion and frame Patient interface for positive airway pressure One mask assembly
CPAP humidifier water chamber Replacement chamber for a heated humidifier One chamber
CPAP standard tubing — 6 ft Patient circuit hose Single; 2-pack
CPAP hypoallergenic filter Air inlet filter 2 filters
CPAP accessories pack Mask, tubing and filter in one kit One kit
Nebulizer accessories kit Mask, mouthpiece and tubing for a nebulizer Single; 3-pack
Portable mesh nebulizer Handheld, USB-C rechargeable aerosol delivery One unit
Desktop compressor nebulizer Mains-powered compressor with a tubing circuit One unit
Portable oxygen concentrator — pulse dose Battery-powered oxygen for ambulation One unit
Home oxygen concentrator — 5 L Continuous-flow stationary concentrator One unit
Peak flow meter Peak expiratory flow measurement Single; 3-pack
Anti-snoring device — mandibular advancement Adjustable oral appliance for snoring Single; 2-pack

Compressor nebulizer or mesh nebulizer: what actually differs?

Both are nebulizing systems, and both are tested against the same document: ISO 27427:2023, fourth edition, published July 2023 and adopted in Canada as CSA ISO 27427:24. What separates them is how the aerosol is generated, and that decides where each device can be used.

A compressor unit is gas-powered. The compressor pushes air through tubing to a cup, so the device sits on a table and the patient holds a mouthpiece or wears a mask at the end of a hose; output continues for as long as the compressor runs. A mesh unit vibrates a perforated plate against the liquid itself, so there is no compressor, no tubing and no mains lead. ISO 27427 lists vibrating mesh (active and passive) among the electrically powered designs it covers, and it does not specify the electrical requirements of those designs — that sits in the IEC 60601 series.

One scope detail belongs in the purchase file. ISO 27427 specifies safety and performance testing of nebulizing systems but does not set a minimum performance level, and it explicitly does not apply to devices intended for nasal deposition, to humidifiers, or to drug-specific nebulizers. The standard tells a buyer how the device is tested. It does not tell anyone how much drug reaches a lung, and no catalogue page can answer that for a given patient.

Which CPAP parts are consumables, and which are patient-specific?

Four parts of a CPAP setup wear on different schedules: the mask cushion or pillow, the tubing, the air filter, and the humidifier water chamber. Every item on that list is patient-specific — a mask, a hose and a chamber are not shared between users, which is why they are supplied as single units or small multipacks rather than in clinic cases.

The filter is the most frequently replaced part and the only one supplied as a two-pack, which matches the common pattern of one in use and one spare. The hose comes as a single or a 2-pack; the 2-pack suits a household with two machines, or a clinic that keeps a spare on the shelf. The water chamber is a replacement part rather than a consumable: heated humidifier instructions specify distilled water and daily emptying, because mineral scale from tap water is what destroys the chamber and, in time, the humidifier.

Is an oxygen concentrator a continuous-flow device or a pulse-dose device, and does it matter?

It matters more than any other specification on this page. The 5 L home concentrator is a continuous-flow unit: it delivers a set flow whether or not the patient is inhaling, and it needs mains power wherever it stands. The portable unit is a pulse-dose device: it senses inspiratory effort and releases a bolus per breath, which is what makes a battery and a shoulder strap practical.

A pulse-dose unit is not a like-for-like substitute for a continuous-flow prescription. A prescription written in litres per minute assumes flow through both phases of breathing; a demand device delivers only when triggered, and at night, or at rest with a shallow breath, triggering is exactly what cannot be assumed. The workable rule is to match the device type to the prescription wording rather than to the patient's preference for portability, and to confirm what power is available at the site before either unit is delivered.

Both device types fall under ISO 80601-2-69:2020 for basic safety and essential performance, and in Canada that document is adopted with Canadian deviations as CSA C22.2 No. 80601-2-69:23. That detail is worth recording: a declaration against the ISO edition alone does not establish conformity with the Canadian adoption.

How does Canada regulate these devices compared with the United States?

The same concentrator or nebulizer crosses two frameworks, and the paperwork differs even where the underlying test standard is shared. In Canada a device is licensed under the Medical Devices Regulations and the establishment that distributes it holds a Medical Device Establishment Licence (CliniEco Medical: MDEL #35334). In the United States the same device sits under a CFR section and, depending on the section, a premarket submission with the FDA. The technical standards converge more than the regulations do.

Respiratory devices: Canadian and United States frameworks compared
Item Canada United States
CPAP / positive airway pressure system Licensed device under the Medical Devices Regulations; distributor holds an MDEL (CliniEco Medical: MDEL #35334) 21 CFR 868.5273, positive airway pressure delivery system
Nebulizer CSA ISO 27427:24, the Canadian adoption of ISO 27427:2023 21 CFR 868.5630; FDA recognises ISO 27427, fourth edition 2023-07
Oxygen concentrator CSA C22.2 No. 80601-2-69:23 — ISO 80601-2-69:2020 with Canadian deviations 21 CFR 868.5440; ISO 80601-2-69:2020 recognised for premarket submissions
Peak flow meter ISO 23747:2015, second edition ISO 23747:2015 — same edition, no national deviation
Labelling English and French English

The requirement that travels least well is labelling. A device sold in Canada carries both languages, so a carton sourced for the American market is not interchangeable stock even when the device inside is equivalent.

Do the same CPAP parts carry the same label in Canada and in the United States?

No, and the difference is visible on the carton rather than in the product. A device sold in Canada carries labelling in both English and French, while the same device sold in the United States carries English labelling and the identifier of its own framework — a licence held under the Medical Devices Regulations on one side, a CFR section and, where it applies, a premarket submission on the other. A mask sourced from American stock is therefore not interchangeable with Canadian stock for a clinic file, even when the two masks are the same model from the same line.

For a buyer the check is one line on the purchase order: the language of the labelling, and the identifier the supplier declares. Both travel with the carton, and neither can be inferred from the model number.

Which items do clinics and care homes reorder, and which are bought once?

Reorder lines are the four CPAP consumables, the nebulizer accessory kits and the nasal rinse sachets. Bought once and then serviced: concentrators, nebulizer units, the peak flow meter and the oral appliance. That split drives the par level, because a budget that treats a compressor and a filter as the same class of purchase either over-holds equipment or under-holds the consumable that stops a therapy.

A workable par level for a care home starts from the number of residents on CPAP rather than the number of beds, and multiplies by the replacement interval the manufacturer states for each part. A clinic supporting home-care clients runs the same arithmetic on active clients. The accessory kit is the line that matters most, because a mask without a hose is not a usable spare.

Related reading

Deeper background on the parts and the choices: CPAP supplies in Canada: filters, tubing and accessories, compressor nebulizer or mesh nebulizer, and oxygen therapy supplies for Canadian home care.

Frequently asked questions

Is a prescription needed to buy a CPAP mask or tubing in Canada?

The mask, hose, filter and water chamber are device accessories, while the licence attaches to the device and the distributor holds the establishment licence. A clinic or home-care provider ordering for a client still needs the machine's prescription on file, because the accessory has to match the make and model in use.

Can a mesh nebulizer replace a compressor nebulizer for every drug?

No. ISO 27427:2023 covers nebulizing systems but explicitly excludes drug-specific nebulizers, so compatibility is answered by the drug's own labelling and the device instructions rather than by the nebulizer standard alone.

How long does a CPAP filter last?

Replacement intervals come from the machine manufacturer's instructions, not from the filter's pack size. The two-pack exists so that a spare is on hand when the change is due; the interval itself belongs in the client's file.

Does a pulse-dose concentrator deliver the same oxygen as a 5 L continuous unit?

No. Continuous flow delivers a set flow whether or not the patient is inhaling, while a pulse-dose unit releases a bolus on inspiration. A prescription written in litres per minute assumes continuous flow, so the device type has to match the prescription.

Where does a care home or clinic start with a respiratory supply programme?

With the prescription and the device model, then the consumable list for each device. The clinic supply planner turns treatment rooms and clinical days into monthly whole packs, the compliance log centre carries the printable records, and institutional ordering runs through the institutional account enquiry page.

Standards and sources

Editions and links were checked on 6 November 2026. 21 CFR 868.5273, positive airway pressure delivery system; 21 CFR 868.5630, nebulizer; 21 CFR 868.5440, portable oxygen generator; FDA recognition record for ISO 27427, fourth edition 2023-07; CSA ISO 27427:24; CSA C22.2 No. 80601-2-69:23; ISO 23747:2015, peak expiratory flow meters; Health Canada, medical devices. CSA and ISO catalogue pages refuse automated requests; the entries above were read from those catalogue records and are cited with their edition dates.

Distribution: CliniEco Medical — MDEL #35334. Formats and pack counts are those printed on the current product listings; confirm the model and the accessories against the prescription before ordering.