How Many Catheter Accessories Kit Does a Canadian Clinic Use Per Month in Alberta?

How many catheter accessories kits does a Canadian clinic use per month in Alberta?

Alberta buyers need a denominator they can defend and an order quantity that survives the transport leg. Here is the monthly calculation across the three operator types that buy drainage kits in the province, plus the reorder point that follows from lead time rather than from an empty shelf.

The Alberta version of this question is asked by a buyer with a spreadsheet, not a nurse with a cupboard. Continuing-care operators in the province run against contracted service agreements and the Continuing Care Health Service Standards, and a supply number that cannot be traced to a denominator somebody signed off is the number that gets challenged. So the useful answer is not a single figure for the province; it is a figure per operator type, with the denominator named beside it.

There is also a physical constraint that BC and Ontario clinics feel less: Alberta is served from a single distribution point in the east. A monthly usage figure is only half of an order quantity. The other half is how many weeks of cover a delivery delay would cost you, which is why this page ends on lead time rather than on consumption.

What counts as one kit in Alberta?

One drainage bag, one length of tubing and the connectors that join them, supplied matched. Alberta buyers tend to ask a second question at the same time — whether the bag and tubing can be sourced separately to save money — and the answer is that separate sourcing works until the connector does not seat. The dimensions behind a small-bore connector come from ISO 80369-7, and the drainage assembly itself is described by ISO 20697. A matched drainage bag and tubing kit is the version where the join was tested by the party that made both halves.

CliniEco catheter accessories kit: urinary drainage bag with tubing and connectors, product photograph on a white background
One kit is a bag, a length of tubing and its connectors, matched and supplied together.

Which denominator does an Alberta operator use?

Designated continuing-care spaces, not population. A contracted long-term care operator forecasts from funded spaces and the share of those residents with an indwelling catheter; a designated supportive living site forecasts from spaces and its own admission pattern; a community clinic forecasts from its own roster of catheterised patients, which is usually small and occasionally surprising. The three produce very different monthly numbers from the same formula, and mixing them produces the order that is wrong in both directions.

One more Alberta-specific question matters before any formulary decision: whether a client is eligible for provincially funded supplies. Alberta Aids to Daily Living is the programme most often named, and eligibility, authorised quantities and the authorisation process are its own procedure. An operator should confirm the current authorisation rule with the programme rather than assume a supply line is client-funded, and should record what was confirmed.

How is the monthly number calculated?

The formula is the same one used anywhere: catheterised people multiplied by thirty divided by the change interval, then grossed up for sets replaced before their scheduled change. What changes by operator type is the denominator and the allowance. The table below is a worked example, not a published benchmark, and the last column is the one auditors and finance reviewers both ask about — who records the change.

Worked example across the three operator types that buy drainage kits in Alberta. Base is denominator × 30 ÷ interval; the allowance should be replaced with the site’s own unplanned-change count.
Alberta operator type Correct denominator Monthly demand base Change interval Sets before allowance Early-replacement allowance Order per month Who records the change
Contracted long-term care operator Funded spaces, catheterised residents 18 residents 7 days 77 15% 89 kits Care aide records on the unit log; nurse signs
Designated supportive living site Designated spaces with catheterised residents 6 residents 14 days 13 20% 16 kits Site nurse records per visit schedule
Community clinic Own roster of catheterised patients 3 patients 21 days 4 25% 6 kits Clinic nurse records in the patient chart

How many weeks of cover should an Alberta site hold?

Lead time decides this, and the arithmetic is short. Take the monthly figure, divide by 4.3 to get a weekly burn, and multiply by the weeks a replenishment actually takes — including the week that is lost to an internal approval, which is usually the longest part of the delay. A site that orders at the moment the shelf looks thin has already ordered late, because the reorder point is not the empty shelf, it is the shelf level at which the delivery will arrive just in time.

Reorder point = weekly burn × lead time, using the 89-kit example above.
Weeks from order to shelf Monthly usage Reorder point What the shelf target becomes
2 weeks 89 41 kits Reorder at 41; shelf target 89
3 weeks 89 62 kits Reorder at 62; shelf target 89
4 weeks (approval + transport) 89 83 kits Reorder at 83; shelf target 89
6 weeks (multi-site consolidation) 89 124 kits Order two-month cover; reorder at 124
Specification diagram listing the contents and intended settings of the CliniEco urology care kit (not a photograph)
Companion specifications sit beside the drainage kit in the same order, which is why consolidating the catalogue shortens the lead time.

What else belongs in the same order in Alberta?

Bed protection and site preparation, for the same reason they are ordered everywhere else: a bag change is the moment a pad is needed and the moment a prep pad is used. The urology care kit with pads and underpads covers the bedding side. Where a site also manages ostomies, the ostomy care kit is a separate order line but the same delivery — and every additional line on a single delivery is one more chance to consolidate, which matters more in Alberta than in Ontario because the transport leg is longer.

Schematic of the CliniEco urology care kit box and its contents, labelled (not a photograph)
Consolidating pads, wipes and drainage kits on one delivery shortens the effective lead time.

Why do two Alberta sites with the same bed count order different quantities?

Three reasons, and they are worth walking through because each one shows up in a budget review. First, catheterised share: a 120-bed operator with a rehabilitation unit carries more indwelling catheters than a 120-bed operator without one. Second, admission pattern: sites that take admissions from acute care receive patients who already have a catheter and a supply tail, while sites with a stable census do not. Third, and most often missed, the issue interval: a site that gives a client two months of kits at discharge shows double the monthly consumption of an identical site that issues monthly, with identical care.

Where does an Alberta operator take this next?

Four routes. The clinic supply planner converts spaces and change interval into a monthly kit count. The compliance log centre supplies the printable record that answers the first inspection question — when it was changed, from which lot, by whom. The long-term care supplies hub collects the rest of the lines these sites order, and multi-site or purchasing-group enquiries are handled through the wholesale account route, where case quantity and delivery frequency are agreed once. Reselling? become a distributor.

Questions that go past a template — a record format a specific inspector asked for, or an interval a policy review is challenging — go to the compliance consultation desk rather than to a generic contact form.

Related Reading

Frequently Asked Questions

How many catheter accessories kits does an Alberta care home use per month?

Calculate it from catheterised residents, not beds: residents × 30 ÷ the change interval, then grossed up for early replacement. Eighteen residents on a seven-day interval with a 15% allowance comes to about 89 kits a month; six residents on a fourteen-day interval comes to about 16.

Does Alberta Aids to Daily Living cover catheter supplies?

That is an eligibility question for the programme, not a product question, and the answer depends on the client and the item. Confirm the current authorisation rule directly with Alberta Aids to Daily Living before treating a supply line as funded, and record what was confirmed so the assumption does not surface at audit.

Why does lead time change the order quantity?

Because a reorder point is not the empty shelf. If a replenishment takes three weeks including internal approval, the site has to reorder when three weeks of stock remain, and with a monthly burn of 89 kits that point is about 62 kits on hand — well above what looks low.

Should the bag and tubing be bought separately to save money?

Only if the connectors are tested as a pair. The dimensions that make a small-bore join reliable come from ISO 80369-7, and separately sourced bag and tubing can mate badly at exactly the moment a nurse is changing a soiled set. Where a kit is used, the join is the manufacturer’s tested assembly.

What must be confirmed before an Alberta site standardises on one kit?

Connector sizing against the catheters actually stocked, bag volume, sterility and single-use status. Our own listing states connector sizing and gravity drainage but does not state bag volume, sterility or single-use status, so those are questions for the supplier before a formulary decision.

CliniEco Medical holds Health Canada MDEL #35334. Provincial funding eligibility and continuing-care service expectations are matters for the operator and the programme, not product specifications. This page is general information about product formats, standards and record-keeping, not clinical advice. Confirm current specifications and order status on the product page. Health Canada MDEL #35334 covers our establishment licence; it is not a statement about any individual product.

Vous travaillez déjà avec des cliniques ? Devenez représentant régional.