A specimen transport bag is a compliance document with a zip on it. In Quebec, a lab or clinic sending Category B biological substances has to demonstrate a three-layer system, a 95 kPa pressure capability and correct marking, and the bag is where all three become visible to a courier or an inspector.
CliniEco stocks UN3373-rated bags in four formats, including the 7 × 11 inch 95 kPa specimen transport bag, 100 per pack, which fits most 90 mL and 120 mL containers with the absorbent pouch in place.
What does 95 kPa actually mean for a Quebec lab?
It is a pressure differential the package must survive without leaking — the packaging is tested to hold the contents if internal pressure changes by 95 kilopascals, roughly the difference between ground level and an aircraft cabin at altitude. The requirement comes from the UN Model Regulations as adopted for Category B biological substances, and it is why a plain zip bag is not a substitute, however thick it feels.
The practical test is whether your primary receptacle, absorbent material and secondary bag are assembled as a system the courier will accept. A 95 kPa bag holding a leaking cup still fails, because the leak has already contaminated the secondary layer before the pressure test matters.
Which bag format fits your specimen volume?
| Format | Fits | Where it is used |
|---|---|---|
| 6 × 9 in | Small containers and swab tubes | Single-sample collection, dentistry, small clinics |
| 7 × 11 in | 90 mL and 120 mL cups with absorbent pouch | General lab send-outs, urinalysis |
| 8 × 10 in | Two or three containers | Multi-test panels, prenatal bundles |
| 12 × 15 in | Bulk and rack transfers | Hospital units, reference lab transfers |
How many bags per case should a Quebec clinic order?
Count the send-outs, not the patients. A clinic that draws blood daily but ships to a reference lab twice a week needs bags per shipment, plus a spare set per courier run. Add the bags consumed by re-bagging after a leak, which is small but never zero. Most small clinics find a 100-count pack consumed within one to two months; a busy collection site will go through it faster than the reorder reminder suggests.
What lead time should you plan for?
Canadian-held stock ships in days to Quebec, and that is the number that matters, because a bag shortage stops send-outs entirely. Anything imported runs weeks. Keep one unopened pack as a floor and reorder at two, and do not let the floor be consumed by a single unusual week.
How should bags be stored and labelled?
Store flat, dry, out of direct sunlight, and away from the freezer, because cold makes the zip track brittle. Label the requisition before it goes into the outer pocket, not after sealing, and never place the requisition inside the bag with the specimen. A bag that arrives with the paperwork in the wrong layer is treated as a packaging failure even when the sample itself is fine.
Related reading
- Specimen bags for Canadian clinics: types and sizes
- Regulatory requirements for specimen transport bags
- Why graduated leak-proof specimen cups matter
Ordering for a clinic, lab or care home? Wholesale and multi-site ordering covers account set-up, and the B2B wholesale collection lists the lines stocked for institutional buyers. Reselling? become a distributor.
Keep the paperwork in one place: print the compliance log sheet, generate a fresh copy with the log generator, and for volume questions talk to the wholesale desk before your next reorder.
Before your next reorder, request a bulk quote for the lines you actually consume, so case counts and delivery windows are agreed in writing.
Frequently Asked Questions
What does a 95 kPa specimen bag actually certify?
It certifies that the packaging can survive a 95 kilopascal pressure differential without leaking, which is the standard applied to Category B biological substances in transport. It does not certify that your assembly is correct, so the primary container, absorbent material and secondary bag still have to be combined as a system.
Which specimen bag size should a clinic stock?
Match the bag to the container rather than to the patient count. A 7 × 11 inch bag holds a 90 mL or 120 mL cup with the absorbent pouch in place, while 6 × 9 inch bags suit swab tubes and small containers. Clinics sending mixed panels usually keep two sizes.
Can a clinic use a heavy-duty zip bag instead of a 95 kPa bag?
No. Thickness is not the requirement; demonstrable pressure performance is. A plain zip bag has no validated 95 kPa claim, so a courier or inspector is entitled to reject the shipment even if the bag feels substantial.
Where should the requisition go in a specimen transport bag?
In the outside pocket, never in the same compartment as the specimen. Paperwork placed inside the bag is treated as a packaging failure because it can be contaminated by a leak and it blocks the visual check the courier is required to make.
CliniEco Medical is a licensed medical device establishment (MDEL #35334).