Buying the supplies in this guide? Distributed in Canada by CliniEco Medical, Toronto.
CliniEco Ostomy Care Kit · CliniEco Ostomy Care Kit · CliniEco Ostomy Care Kit · Wholesale & clinic accounts
Products referenced in this guide
Ostomy Care: Step-by-Step Guide to Changing an Ostomy Pouch Safely
For Canadian ostomates and healthcare providers, mastering the ostomy pouch change procedure is essential for maintaining peristomal skin health, preventing leaks, and ensuring confidence in daily life. Approximately 15,000 ostomy surgeries are performed annually in Canada, and over 100,000 Canadians are living with an ostomy. This step-by-step guide covers everything from supplies to troubleshooting.
How Often Should You Change an Ostomy Pouch?
Most ostomy pouches should be changed every 3-7 days, depending on the type of stoma, output consistency, and skin condition. The pouch should be emptied when it is one-third to one-half full — typically 4-6 times per day for ileostomies and 2-4 times for colostomies. Key indicators that a change is needed include: Specification and standards detail is covered in ostomy supply planning for facilities.
- Leakage under the skin barrier
- Itching or burning sensation around the stoma
- Visible breakdown or discoloration of the barrier
- Odour escaping from the pouch
Supplies Needed for an Ostomy Pouch Change
Before starting, gather the following supplies:
- New ostomy pouch and skin barrier (one-piece or two-piece system)
- Stoma measuring guide or template
- Scissors (for cutting the barrier opening)
- Stoma paste or convex ring (if needed)
- Adhesive remover wipes or spray
- Skin barrier wipes or powder
- Gentle cleanser or warm water
- Soft washcloth or gauze
- Trash bag for used supplies
- Optional: ostomy belt, stoma powder, skin filler
Figure 1: Coloplast SenSura® Mio Convex two-piece ostomy system. (Source: Coloplast Canada)
What are the key measurements and look-outs at each step?
A printable step card for the change; the full narrative sits below. Print this table
| Step | Action | Key measurement or look-out |
|---|---|---|
| Remove | Push skin away from the barrier, never pull | Use adhesive remover to protect the skin |
| Clean | Warm water and a soft cloth; pat dry | Avoid alcohol wipes and moisturising cleansers |
| Inspect | Check for redness, rash, bleeding, irritation | Healthy peri-stomal skin matches the abdomen |
| Measure | Trace the exact stoma size and shape | Opening about 1/8 in (3 mm) larger than the stoma |
| Cut | Trace and cut the barrier; round the edges | Sharp corners lift and leak |
| Seal and apply | Paste or convex ring, then centre and press | Hold 30-60 seconds for adhesion |
| Secure | Gentle hand pressure over the whole barrier | Two to three minutes lets body heat set the adhesive |
Empty the pouch when it is one-third to one-half full; change frequency is usually every three to seven days. Follow your WOC nurse's plan for your own stoma.
Step-by-Step Ostomy Pouch Change Procedure
- Prepare the area: Lay down a towel or underpads. Remove the old pouch by gently pushing the skin away from the barrier — never pull the barrier off the skin. Use adhesive remover wipes to dissolve the adhesive and prevent skin trauma.
- Clean the stoma: Gently clean the peristomal skin and stoma with warm water and a soft cloth. Pat dry completely. Avoid alcohol-based wipes, harsh soaps, or moisturizing cleansers.
- Inspect the skin: Check for redness, rash, bleeding, or irritation. Healthy peristomal skin should look the same as skin elsewhere on the abdomen.
- Measure the stoma: Use a measuring guide to trace the exact size and shape of the stoma. The barrier opening should be 1/8 inch (3 mm) larger than the stoma.
- Cut the barrier: Trace the measurement onto the back of the skin barrier and cut carefully. Round the edges to prevent sharp corners from lifting.
- Apply stoma paste or ring: For flush or irregular stomas, apply a convex ring or stoma paste around the opening to create a custom seal.
- Apply the barrier: Remove the backing from the skin barrier. Center the opening over the stoma and press the barrier onto the skin, working from the stoma outward. Hold for 30-60 seconds to ensure proper adhesion.
- Attach the pouch: If using a two-piece system, snap the pouch onto the flange. Ensure you hear the "click" confirming a secure seal. For one-piece systems, the pouch is pre-attached.
- Secure the system: Apply gentle hand pressure over the entire barrier for 2-3 minutes. Body heat helps activate the adhesive.
- Final check: Ensure the pouch is properly positioned, the drain is closed, and there are no gaps or wrinkles in the barrier seal.
Figure 2: Hollister CeraPlus™ Ostomy Skin Barrier with Ceramide Technology. (Source: Hollister)
Troubleshooting Common Ostomy Issues
| Problem | Possible Cause | Solution |
|---|---|---|
| Leakage under barrier | Opening too large; stoma retraction | Re-measure stoma; try convex barrier |
| Itchy/red skin | Allergic reaction; fungal infection | Switch barrier brand; consult WOC nurse |
| Pouch odour | Poor seal; diet; worn filter | Check seal; replace filter; use deodorant |
| Barrier won't stick | Moisture; powder residue | Dry skin thoroughly; use skin prep wipe |
| Bleeding stoma | Friction; trauma; vitamin deficiency | Gentle cleaning; apply light pressure; see doctor if persistent |
Product Selection for Canadian Ostomates
In Canada, ostomy supplies are available through provincial programs such as Ontario's Assistive Devices Program (ADP), Alberta's AADL, and BC's Medical Supplies and Equipment (MSE) Program. Leading brands available through Canadian distributors include:
- Coloplast: SenSura® Mio, Assura®, Alterna®
- ConvaTec: ActiveLife®, Sur-Fit® Natura®, Durahesive®
- Hollister: New Image™, CeraPlus™, Vertical™
- Smith+Nephew: OpSite® Flexigrid™
CliniEco Medical offers a full range of ostomy care products from all major manufacturers for Canadian hospitals, LTC facilities, and home care. Our team can assist with product selection and bulk procurement for your facility.
Have a question about your own facility? Send it in and you will get a written answer specific to your setup, with the regulation or standard it is based on cited. Ask your compliance question.
Related reading: learn more about Canadian medical procurement in our business hub.
Planning monthly volumes? incontinence supply planner — it estimates monthly volumes and cost, and prints a checklist you can tick off with your team.
Where to Buy Sterilization Packaging & Monitoring in Canada
Frequently Asked Questions
How often should an ostomy pouch be changed?
Most two-piece systems change the pouch every two to three days and the wafer every three to seven, while a one-piece system is usually changed every one to three days. The interval shortens when the seal lifts at the edge, when output leaks under the wafer, or when the skin underneath becomes red. What matters for ordering is the wafer count rather than the pouch count, because wafers set the monthly quantity.
What belongs in a home care ostomy kit for one client?
Build for a week: two pouches, one barrier ring or paste, adhesive remover wipes, skin cleanser, and a pack of dry washcloths, 500 per case for cleaning around the stoma. Add a 30 by 36 inch heavy absorbency underpad for the chair or bed the change happens on, and keep a spare change of clothing in the bag so a leak does not end the visit.
Which underpads and briefs support a client during a change?
A 30 by 36 inch underpad with a five-layer build and superabsorbent core holds the small spill that happens when a pouch is opened, and it is cheaper than remaking a bed. Where the client also manages urinary incontinence overnight, a Night Plus brief rated at 5,000 millilitres covers the longer interval, while a Day Comfort brief at 3,000 millilitres suits daytime use.
How should a used pouch be disposed of?
Empty the pouch into the toilet, wipe the inside, then wrap it and place it in household waste; it is not recyclable and it does not go into a biohazard bag unless it is saturated with blood. A double bag is reasonable when the pouch cannot be emptied first. Where the client is on home parenteral therapy or produces blood-soaked dressings, that waste follows the provincial rule for home-generated biomedical waste instead.
Which supply lines does a home care team reorder every month?
Ostomy kits, catheter drainage supplies, underpads, washcloths and briefs move together, so order them on one cycle rather than four. A team running 40 clients typically holds two weeks of cover on each line and reorders when the shelf falls below that point. CliniEco Medical stocks the convex ostomy care kit, a catheter drainage accessory kit and a urology care kit on the same ordering page.
CliniEco Medical supplies these from Ontario with published CAD pricing (MDEL #35334) — no quote required, and each pack ships with the lot number printed on it so your monitoring record stays traceable.
| Format | Pack size | Price (CAD) | |
|---|---|---|---|
| 24-hour self-contained BI | 25-pack | $69.99 | 24-hour self-contained biological indicators — 25-pack |
| 24-hour self-contained BI | 100-pack | $189.00 | 24-hour self-contained biological indicators — 100-pack |
Round Out Your Sterilization Setup
A biological indicator is one link in the chain — these are the pieces it works with:
- Sterilization pouches — Class 4 dual-indicator, 200-pack — the packaging the indicator rides inside
- Autoclave indicator tape — 3-roll set — the external chemical indicator on every pack
- Class 5 chemical integrators — 100-pack — the in-pack check that pairs with your biological indicator
- Sterilization roll — 50 m pre-cut sheets for larger instruments
- Constant-heat pouch sealer — 200 °C, 12 mm seal — for consistent pouch closures
Which format does your sterilizer actually need?
Match the readout time to how fast you need the result: a 24-hour self-contained indicator works in any gravity or pre-vacuum cycle with a standard incubator, while a 3-hour fluorescence tube needs the matching reader. Running one cycle type per day, the 25-pack covers a month; busier clinics move to the 100-pack and cut the per-test cost.
How much do spore tests cost in Canada?
Published pricing runs $2.80 per test on the 25-pack down to $1.89 on the 100-pack — no distributor quote, no account needed.
Not sure which format your sterilizer needs? Generate a free sterilization log sheet first — it maps your cycles and tells you the pack size that fits. Questions about your setup? Ask a Compliance Specialist.